0
What else can I help you with?
Why would the turn signals and hazard flashers on a 2001 Lumina all fail at the same time?
Because the hazard/turn signal relay has failed. A defective/intermittent turn signal switch can also cause this symptom.
Why would the turn signals quit working when the hazard lights still work and the flasher and bulbs have been replaced on a 1995 Chevrolet Corsica?
Check the flasher for the turn signals which is under the dash on the left side of the steering column . It is different from the emergency flasher.
How do you get to the flasher on a 2004 Chevrolet Malibu?
The flasher is actually the hazard switch itself. If removed turn signals will not function. Just pop the old switch out and unplug it to replace if broken (if present and signal don't work).
What could be the problem with a 2001 Audi A4 Quattro if the hazard lights work but the turn signals only blink once?
My research to date finds that the turn signals and hazard signals are controlled by a common relay. That relay is behind the hazard relay switch. My 2002 Audi A6 has the same symptoms you describe, and I will be removing the hazard switch to get at the relay for replacement. Good luck.
What would cause the hazard signals and the turn signals not to work on an Audi A4 1996 1.8T?
Flasher is faulty.
What is the problem if the turn signals work but the hazards do not?
Often, a separate flasher unit is used to activate the hazard flashers. This unit might be bad, or the switch to activate the hazard flashers might be bad. answer always there are 2 flashers.one for turn signals other for hazard replace hazard flasher They have separate fuses also.
How do you fix the turn signals on the early version 2001 Passat?
If the turn signals are inoperative check the hazard switch, if the hazards don't work replace the hazard switch, the signals will start working. if the hazards are ok ,the turn signal switch may be bad.
2001 Chevy Malibu signals doesn't flash all the time when needed?
there is actually a recall on this Nature of Defect:2. EXTERIOR LIGHTING:HAZARD FLASHING WARNING LIGHTS:SWITCH Recall Number: 03V327000 Dates Manufactured: Mar 2000 to May 2001 Number of Vehicles Affected: 670740 Date Owners Notified On: N/A Vehicle: 2001 Chevrolet Malibu Defect Description:CERTAIN PASSENGER VEHICLES HAVE HAZARD WARNING SWITCHES THAT MAY EXPERIENCE SOLDER JOINT CRACKING CAUSED BY RAPID TEMPERATURE TRANSITIONS AND THE SOLDERING PROCESS. IF SOLDER JOINT CRACKING OCCURS AND RESULTS IN AN OPEN CIRCUIT, THE TURN SIGNALS/HAZARD LAMPS BECOME INTERMITTENT OR INOPERATIVE. Consequence of Defect:WHEN THE TURN SIGNALS ARE INOPERATIVE, THE DRIVER CANNOT USE THEM TO SIGNAL INTENT TO TURN THAT COULD RESULT IN A CRASH. Corrective Action:DEALERS WILL REPLACE THE HAZARD WARNING SWITCH. OWNER NOTIFICATION BEGAN ON FEBRUARY 5, 2004. OWNERS SHOULD CONTACT CHEVROLET AT 1-800-630-2438, PONTIAC AT 1-800-620-7668, OR OLDSMOBILE AT 1-800-630-6537.
Is the flasher built into the hazard switch that's all I have found behind the hazard button on a 2001 Chevrolet Monte Carlo?
yes
What is wrong when the hazard and turn signals don't come on in a 2002 Chrysler sebring convertible?
turn signals won't work. changed all the bulbs. Hazard lights work. 1999 Chrysler Sebring hardtop
What does the multifuction switch control in 1995 ford explorer?
The multi function switch is inside your steering column cover and the hazard button and the turn signal lever stick outside of the steering column cover ( so , turn signals , flash to pass , high beam headlights , windshield wipers - high / low / intermittent settings , windshield squirter button , hazard flashers ) I had mine replaced when 2 of the intermittent wiper positions did not work and I would have to push the windshield washer squirter button 3 times before I would get any washer fluid
Turn Signals and Hazard do not work 2003 Chevy Tahoe?
Check the fuse
