sounds like the flywheel could be lose. does it do it all the time while driving or just shifting
no the bell housing is different as is the spline for the clutch
That involves removing the axles the tranny. I just replaced the clutch and tranny on my 95 tercel and it's not fun.
unbolt tranny from engine clutch is between them
Could be bad hydraulics? Possible it just wore out. or tranny fluid, tranny seal, clutch pads, tranny silinoid. autozone.com has an online q&a about autos, check it out
don't try to put trans fluid on clutch. manual tranny uses 40wt oil.
No, tranny comes out the bottom.
The 400 tranny on a 1983 Chevy 6.2L K20 diesel have very high pressure.
Bad reverse clutch in the tranny
A transmission that does not use a clutch and pressure plate to disconnect from the engine.
That's pretty much a given with changing any clutch or torque converter.
have to completely pull tranny and 4 wheel diff.then replace clutch and re-install back in. Not for a novice,may want to leave this one to the tranny man.
Your clutch is worn out,your pressure plate is shot,or there is a broken spring inside your clutch,you have to drop your tranny to check this out,been there ,done that! good luck,,toro2.