0
What else can I help you with?
When buying a sub woofer and an amp is it better for the amp to match the subs rms wattage or is it better to match the max wattage?
Yes unless you want to smoke your subs
How big of an amp do you need for to 17 inch subs?
for Two* 17 inch subs? Assuming this is what you mean, your question is still completely unanswerable. All you have to do when getting an amp is basically to match up the RMS Wattage on the Subwoofers to the RMS Wattage output on the amp. Impedance will factor into this as well.
How do you hook up subs on stock radio for Lexus es300?
I hooked up a non stock stero now my tail lights went out I installed a new fuse but it blew...what could be the problem?
Can a sealed sub box have more volume than the subs require?
It could damage your subs. And it may not sound as good. Your subs will not play to there full potential.
93 ford probe you hooked up a new radio but theirs no sound but the subs work?
check all the ground wires cause the bad grounds will make that happen
Which sub can you select for m tech?
the subs name is m the subs name is m the subs name is m the subs name is m the subs name is m
How large fast and dangerous were submarines in world war 2?
The largest subs in WWII were the Japanese I-400 Class subs; they could launch 3 airplanes.
What is the best way to wire 2 svc 2 ohm subs with a Rockford Fosgate T500 1db?
How much power can the subs take in terms of RMS wattage? You can either wire them to a 4 ohm load where they will each see 125 watts, or to a 1 ohm load where they each get 250 watts. Rockford Fosgate supplies a very useful feature for showing how to wire the subs for the impedance that you want: http://www.rockfordfosgate.com/rftech/woofer_wizard.asp
Your rockford fosgate amp keeps going into protection mode when you hook up the power wire?
you might have you subs hooked up wrong i the box idk check and make sure might blow um
What ohms am i running if i have two 4 ohm speakers hooked up to my amp vs two 2 ohm speakers?
Don't know how you have subs wired but should be 4 ohm load is what your amp will see.
Speakers in f150 what size fornt and back?
front speakers and back speakers are both 6x8 speakers
How much watts should you get in a amp for two 700 watt subs?
To properly power two 700-watt subwoofers, you should aim for an amplifier that can deliver at least 1400 watts RMS (root mean square) total, assuming the subs are wired in parallel. This allows for sufficient power for both subs to perform optimally without distortion. It's also advisable to choose an amp with a bit more wattage than needed to ensure headroom, so a 1600 to 2000-watt amp would be ideal. Always check the specific impedance ratings of your subs and amp for compatibility.
