0
93 Geo right low beam doesn't work but the left does and the high beams work for both?
You probably just have a burned out light bulb. Look at the back of the sealed headlights. You will see two connectors, one for the high beam and one for the low- beam. To remove the light bulb turn the bulb holder counter clockwise until it releases. Replace the bulb and holder. Make sure you don't get oil from you hands on the bulb or it may shorten the operating life.
What else can I help you with?
1992 Saturn SC Hi beams work on both headlights Lo beams only work on drivers side. Changed right with left and left with right but right lo beam still not working.?
right side low beam is burned out
Your 1988 Volvo headlight is out does that effect the highbeam on both the left and right lights?
When one of the low beam burnt out you still have high beams on both sides although it isn't receommended you drive with the high beams on because you run the risk of everyone calling you names since your blinding them . NO it doesnt effect anything, just replace the bulb the run about 12 bucks
Why does 240sx high beams work on both headlights but not low beams?
the bulbs in your car have two filaments, high beam and low beam. as you generally use mainly low beam the filament wears out a lot quicker than high beam. so replace your bulbs, as it couldn't be anything else.
Why dont your high beams turn on but your low beams both work on your 2000 ford expedition Is there a fuse for it?
It sounds like the low beam/high beam switch is bad. Fuses are not the problem since they are built into the headlight switch and would cause headlights to blink or not come on for both high and low beam headlights.
Does the 1999 Toyota Camry have low beam and high beam light bulbs?
Camry 1999 has only on bulb for both low and high beams.
Your low beam headlights work but not high beam for 1992 camaro rs?
the high beams work off of a different fuse , both low beams are on the same fuse. fuse panel under dash on drivers side
What is a elastic coupled beam?
Two beams are said to be elastically coupled when central deflection in the lower beam (due to load on midspan) is equal to the central deflection on the upper beam plus the extension in suspension rod by which both are suspended
How can i get my 98' trans am headlights to both turn on when i have high beams on?
There are two elements in every headlight. One is for low beam (normal usage) and one is for the high beam. The high beam element tends to burn out sooner than the low beam, and it is very possible that one of your high beam elements has simply burned out. The solution is simple. Replace the offending headlight and you'll have both high beams back.
On a 2003 Chevy trailblazer Do both bulbs come on when the high beams are turned on?
yes,4 separate bulbs,2high beam-2 low beam
What would cause both 'low beam' lights to not work but still allow the 'high beams' to operate on a 1993 Mazda 323?
Have you checked to make sure both bulbs are not burnt out on low beam? Even if it is a single bulb for both high and low beam the low beam filaments could be burnt out.
Are w shape steel beams doubly symmetric or singly symmetric?
The "W" in steel I-beam designations refers to wide-flanged beams. Most wide-flanged beams are symmetric about both the vertical and horizontal axes.
What does Bulb failure dipped beam?
It means you have a headlamp out. Check both high and low beams. They use the same bulb for both. It should be an H7.
