answersLogoWhite

0

IS this a 5.2, if so the crank sensor is on the passenger side of the engine, in the far rear, it picks up off the flywheel, the cam sensor is located inside the distributor (it is the pick up coil).

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

What is the location of cam sensor for 08 dodge cummins?

Lower/front/driver side of the block. The one aiming at the crank pulley is the crank sensor. The cam sensor is just above it.Lower/front/driver side of the block. The one aiming at the crank pulley is the crank sensor. The cam sensor is just above it.


Is there a cam and crank sensor on 4.7L dodge?

Yes.Yes.


Where is crank sensor on a 1991 Dodge 150 van?

A 1991 doesn't have a crank sensor, it only has a distributor pick up plate(cam sensor)


Where is the crank position sensor on 1990 Dodge Dakota 3.9L?

No crank sensor on a 1990, only the pickup plate (cam sensor) in the distributor. how about a 1991?


Would a crank shaft sensor and cam sensor cause your 2002 dodge grand caravan to not turn over and or start at all?

A bad cam or crank sensor can cause a no start, but the engine will still crank or turn over.


Will not crank no fire codes OK coil OK 96 Dodge Intrepid 3.5 what to mlook for?

try crank position sensor and cam shaft sensor


Location of cam sensor on a 2000 dodge Dakota 4.7l?

Under the front of the right cylinder head. If you look up from underneath you can see the three wire connecter. ************please note that this answer is wrong...this is the location of the CRANK SHAFT SENSOR****************


Dodge Dakota crank sensor what is it for?

most crank sensors are for engine timing with the cam shaft, the distributor on at least 97' dodge and newer controls fuel timing.


You would like to locate cam shaft sensor and crankshaft sensor for 1991 dodge caravan 3.0?

Crank sensor is in the top of the transmission housing at the back of the engine. Cam position sensor is in the distributor.


Is the crankshaft sensor the same thing as a camshaft sensor?

No. The crank sensor reads the crankshaft location and speed. The cam sensor reads the camshaft.


Do you need to replace cam sensor after replacing the crank sensor?

if you have a code w/ cam to crank reference then yes. if only a crank sensor issue the no


Will a speed sensor in a 1998 dodge neon stop the car from starting?

Crank and cam sensors, yes. Vehicle speed sensor, no.

Trending Questions
How biodiesel is manufactured? How do you bleed the cooling system on BMW 745Li 2004 without the bleed screw? How do you get a broken fuse out of the fuse box in a 92 s10? Where is fuse box on 1990 Cadillac allante? Where can you find the stereo wiring diagram for a 1992 Subaru Legacy? What is the cost to replace intake gasket on 1997 Pontiac transport? What is alternator in motors? Has fuel new battery and new alternator car will run but when turn it off will not crank back up the car don't run hot could it be a faulty wire or do you need a tune-up? 1997 Cadillac Deville that the blower motor fan that controls the heat continues to run even without the key in the ingnition you had the switch replaced and it is still doing the same thing? Would a leaking cylinder head gasket make a car blow blue smoke and would the smoke be continuous? Can you rotate the tires on a 07 gxp with different size tires? Is a fuel filter the same as an oil filter? Why does the brake light fuse keep tripping on your 2001 ford ranger The tail and reverse lights work fine? Where is the Throttle Positioning Sensor located on a 2001 LHS Chrysler? Where is the turn signal flasher in a 1990 Ford Aerostar? Where can Aprilaire furnace filters be bought? How do you replace rear shocks on 1989 dodge d100 pickup 2 wheel drive? Nissan 300ZX 1990 don't start with its battery but starts with a jumper from another car The battery voltage when the car is running is 10Volts. Is the voltage correct for this model what can be wrong? Why is a battery cell is boiling? Can a bad fuel pressure regulator cause the check engine light to come on?