0
What else can I help you with?
How do you replace a crank angle sensor on mercury sable?
You need to remove the serpentine belt and alternator in order to get the crank sensor; one 10mm bolt holds it. It is easy to replace.
Where is 95 silverado crank sensor located?
The 95 models did not use or have a crank sensor. If you are not getting any fire at the plug wires, then you probley need to replace the ignition module that is inside of the distributor.
How can I replace a bike crank?
To replace a bike crank, you will need to first remove the old crank by loosening the bolts that hold it in place. Then, you can install the new crank by aligning it properly and tightening the bolts securely. It is important to make sure the crank is compatible with your bike's bottom bracket before replacing it.
Do you need a crank sensor on a dodge stratus?
Yes. The crank sensor tells the coil when to fire.
Crank sensor location 84 Chevy 2.0?
They did not use a crank sensor in 1984, There was no need for 1
2001 Chevy astro van will not stay running when accelated replaced fuel pump replace mass air flow sensor replaced throttle position sensor crank sensor when you start it it misfires for a little bit?
probably misaligned your crank sensor.. I'm dealing with the same problem, might need to replace with new and make sure to gap properly.
Can a bad crank position sensor cause a hard start problem on suzuki vitara 2 liter when hot and where is it located?
i need to know. my1996 1600 geotracker engine carries a crank sensor, i am replacing it with a vitara engine but it does not carry a crank sensor. the vitara distributor only has two wires. how do i configure, cause the geo distributor has 7 wires
Where is the crank sensor located on a 1995 Oldsmobile Aurora 4.0?
The 1995 Oldsmobile Aurora 4.0 liter engine crank sensor is located on the back of the crank. You will need to remove the rear engine cover in order to view the crank sensor.
Where is the camshaft position sensor on a 1993 4.0 L Grand Cherokee LTD?
On the top of the bell housing. thats the crank position sensor the cam sensor in a 93 is fixed in the distributor to replace it you need a new distributor
What is the labor to replace a crank sensor on a 1997 Toyota Corolla?
About 15 minutes , it is external need to lift vehicle if your timing belt cover is plastic!
Will i damage my car if i don't replace the knock sensor when they need replacing?
the knock sensor cuts the engine out so it won't damage the car if not replaced, the car just won't work.
How do I go about replacing a bike pedal crank?
To replace a bike pedal crank, you will need to first remove the old crank using a crank puller tool. Then, you can install the new crank by attaching it to the bottom bracket spindle and tightening the bolts securely. Make sure to follow the specific instructions provided by the manufacturer of your bike crank for proper installation.
