answersLogoWhite

0

When setting up the clutch cable i usually pull on the cable at the firewall end so I'm pulling the cable into the engine bay. the nut should sit about 4 mm away from the fire wall. that's usally pretty close.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

1996 xr6 Ford ute?

1996 ford falcon xr6 ute is in the XH range. the XH's range is April 1996-1999. it is hard to tell exactly what you are asking but hope this helps :P


Where do you fill the water up in your Ford Falcon ute xh 1996?

In the water bottle.


Where is the horn located on a Xh Ford Falcon ute?

tucked in behind the front bumber bar. in front of the a/c condenser


Where are the fusible links in a xh falcon ute?

T bothsides.


When was Ford XH Falcon created?

Ford XH Falcon was created in 1996.


Where is the transmission fluid dip stick in a ford XH Longreach ute?

It does not have one The automatic gearbox is out of the EL Falcon while the engine is carried over from the XG Longreach!


Is the air temp sensor on the back of the inlet manifold on a 97 xh Ford Falcon ute?

assuming it's the 4 litre. yes it is. hard to change on the ground. easy to get from under the car.


Wiring diagram ford xh falcon ute?

The wiring diagram for a Ford XH Falcon Ute provides a detailed schematic of the vehicle's electrical system, including connections for the engine, lighting, and various components. It typically includes color codes for wires and pinouts for connectors, aiding in troubleshooting and repairs. For specific diagrams, it's best to refer to the vehicle's service manual or online resources dedicated to Ford Falcon enthusiasts. Always ensure safety by disconnecting the battery before working on electrical systems.


Xh falcon ute had a misfire at low rpm now it has no spark?

requires new coil & dizzy


How disconnect smart lock on a XH ford ute?

To disconnect a smart lock on a Ford Ute (XH model), start by removing the vehicle's battery terminal to prevent any electrical issues. Next, locate the smart lock module, typically found near the driver's side under the dashboard. Disconnect the wiring harness attached to the module, ensuring you handle the connectors gently to avoid damage. Finally, reattach the battery terminal and test to ensure the system is fully disconnected.


How do you get to the petrol tank to fix a leak in an XH FALCON ute is the access under the plastic tub liner?

yes


Where is the inlet manifold on a XH ford Ute 97?

open the bonnet, alloy part bolted to the R/H side of engine is the inlet manifold. NOTE: IF you need to ask this question do not attempt any maintenence yourself.