What it probably needs is to be driven so it can relearn it's idle. After disconnecting the batery, the Computer loses it's memory. IT needs to be driven so it can make new fuel-air adjustments to the conditions it has. Pukenstein@aol.com
First clean battery connections, if this does not correct problem the battery needs replacing.
It would help to know the sensor that needs resetting.
Battery located under drivers seat. When replacing the battery in an MMI equipped. vehicle, resetting of the system may be required at a dealership. Battery is vented to outside of vehicle.
The time would only "reset" if the clock battery on th motherboard has died. Replacing the battery should eliminate the problem.
WHOA! This is a trick question. The computer should not need resetting after replacing a battery. The first step in any procedure requires you to disconnect the battery. This is so the computer doesn't receive any false codes while repairing the vehicle. Thus replacing the battery should have cleared any stored codes during the swap. If your car is throwing a check engine light, there is a sensor problem and you'll need a diagnostic code reader to retrieve it.
There is no such thing as resetting a battery. You can recharge it but not reset it.
Reset a battery? There is no such thing as resetting a battery.
how to replace a mitsubishi endeavor battery
The relearn process for battery replacement on a Mitsubishi 3000GT involves resetting the vehicle's ECU to adapt to the new battery. After disconnecting the old battery, you should allow the car to sit for at least 10 minutes before connecting the new battery. Once connected, start the engine and let it idle for about 10 minutes to allow the ECU to recalibrate. Additionally, you may need to reset the clock and radio settings, as these may also be affected by the battery change.
I believe you need to drive it so the ECM relearns it's idle.
There is no such thing as resetting an automobile battery. You can recharge it but you cannot reset it.
For me the reason the clock and stereo were resetting was because they were losing all power from the battery. The battery was dead. maybe your cables need to be cleaned or there is a loose connection.