If the airbag warning light on a Land Rover Discovery 3 is illuminated, it typically indicates an issue with the airbag system, which could range from a malfunctioning sensor to a problem with the airbag module itself. It's important to address this warning promptly, as it may mean that the airbags will not deploy in the event of an accident. You should use a diagnostic tool to read any fault codes and consider consulting a qualified mechanic or dealership for repairs. Ignoring the light can compromise passenger safety.
One can reset the brake warning light on the discovery 3 by resetting one's brake pads to the original manufacturer's settings and checking if they have been worn through.
DISCONNECT THE NEGATIVE BATTERY LEAD AND WAIT 1-3 MINUTES THIS WILL RESET THE COMPUTER THAT REGULATES THE IDIOT LIGHTS
To turn off the passenger airbag in a Land Rover Discovery 3, locate the airbag switch, which is usually found on the dashboard or in the glove compartment. Use the vehicle key or a flat-head screwdriver to turn the switch to the "off" position. Always check the dashboard indicator light to ensure that the airbag has been successfully disabled. It’s important to consult the owner’s manual for specific instructions related to your model.
The airbag light stays on for a couple of reasons. 1. If the computer detects a malfunction and sets a code. 2. If the computer loses power (blown fuse) 3. If the computer loses the connection to the warning light the light comes on.
Depending on which warning light(s) is illuminated on your dash, they represent the 3 amigos.Each amigo adds barney to any individual vehicular function.
The airbag light stays on for a couple of reasons. 1. If the computer detects a malfunction and sets a code. 2. If the computer loses power (blown fuse) 3. If the computer loses the connection to the warning light the light comes on.
You cant!
handbrake light
The airbag light stays on for a couple of reasons. 1. If the computer detects a malfunction and sets a code. 2. If the computer loses power (blown fuse) 3. If the computer loses the connection to the warning light the light comes on.
1. Car off, all belts unbuckled, parking brake on 2. Turn key to on position. you will see seat belt warning light light up red 3. After 1 min you must buckle and then unbuckle seat belt you want to disable warning for 9 times exactly and finish doing this within 50 seconds of the light going off 4. Airbag light will go on for 3 seconds or so 5. After it goes off, buckle then unbuckle seat belt again 1 time 6. Light will flash, seat belt warning disabled.
Most of the light on the dashboard are Warning Lights; different warning lights that might flash up on the dashboard. Some of the more common warning lights are shown below. 1 = Oil pressure warning light 2 = Battery charge warning light 3 = Brake system warning light 4 = Engine warning light
Most OBD II, III, scanner can not reset the airbag light.. When comes to KIA Rio the best way to reset "Airbag Light" take it to your delar, it will take the mechanic about 3 to 5 min. to do it. Normaly no charge... atleast to the customer-service oriented dealers.