0
Yes, tie rod ends for a 1997 Ford F-150 are side specific. The left and right tie rod ends are designed to fit their respective sides of the vehicle, as they may have different lengths or angles to accommodate the steering geometry. It's important to ensure you purchase the correct part for each side to maintain proper steering performance and alignment.
What else can I help you with?
Where is the airbag module located on a 1997 Ford f150?
The airbag module for the 1997 Ford F150 is located in the passenger side kick panel below the dash. It is silver and black in coloring.
Where is the low side for the ac on f150?
The low pressure side of any AC system begins at the metering device outlet and ends at the compressor inlet.
What cylinder is number four on 1997 f150 4.6L?
rear passenger side....all the way at the back
What year did ford put air bags in the f150 truck?
drivers side in 1994 passenger in 1997
Where is the gem module located on a 1997 ford F150?
Drivers side under the dash...above the fuse box
Where is the oil sending unit located on a 1997 Ford F150 4.2 liter?
Front drivers side of engine.
How can you find the 2 cylinder on your 1997 F150 4.6 liter engine?
its the 2nd cylinder back on the rider side of the engine
What Are the Spark Plug Numbering on a 1997 Ford F150?
down the right side... starting front to back 1,2,3,4 left side, front to back 5,6,7,8,
Where is the blower motor resistor in a 1997 Ford F150?
It's located inside the on the passenger side under the glove compartment. Also the blower motor is the same type for all F150 from 1997 to 2003. Allen Bouvier, Fort Simpson, Northwest Territories, Canada.
Where is the starter solenoid on a 1997 Ford F150?
It is located in the engine compartment on the passengers side firewall. the solenoid is located under the hood
Where is fuel filter on 1997 Ford F150?
most ford truck fuel filters are on the frame , drivers side near the gas tank.
Will a transmission from a 1999 explorer fit a 1997 ford f150?
As long as the numbers match on side of trans the only problems you will have is the vss was moved to the rear diff in 1998 so the 1997 would need an entire wire over but if the f150 is. 4x4 then the speed sensor is in the transfer case which means your fine
