answersLogoWhite

0


Best Answer

yes

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Can 5v 1amp charger charge a 5v 2amp battery?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Can you charge a 6 volt battery with a 12 volt battery charger on slow 2amp charge?

No.


How do you charge a battery on 1300 vtx?

Use a battery charger with a 2amp charge. Takes a few days. These small batteries don't like to be charged too fast with high amps.


Is a Intelligent Battery Charger -Motomaster Nautilus for deep cycle batteries the equivalent of trickle charger manual says it does not act as trickle charger can i leave it on for long periods?

Yes it has a 2amp trickle charge


Can I use a 12v 2amp car charger for my exide quad battery?

Yes


What is the difference between 2amp 4amp 6amp battery chargers?

The difference between a 2amp, a 4amp and a 6amp battery charger is the speed at which the battery will be charged. The numbers represent the maximum amperage output at a specific voltage at which the battery will be charged.


How do you charge a battery in a 1989 Honda Shadow?

Remove the battery, or disconnect it, and with any 10 amp/ 2amp, charger, pos to pos, neg. to neg. and charge it at 2 amp, till it is full. If you need to add water, add only distilled water to top the battery up. Use a charger with auto-shut off.


Can you use a 2Amp Car battery charger on a 12 volt sealed leak proof battery?

First the maximum charging current for the battery should be checked. If that is unknown it can be taken as one tenth of the capacity, e.g. 2 amps max for a 20 Ah battery


How many kilowatts does a television use?

Normely Television use with single phase 230vac & Television watts 150w to 50w,Current is 1amp to 2amp,Use 5Amp Socket.


How long do you charge a riding lawn mower battery at 12volt 2amp charger?

Charging time varies greatly, dependent on the batteries condition at the beginning of the charge cycle. Most modern battery chargers are automatic and will reduce charge amps as the battery becomes fully charged. If your charger is a manual type, there are two ways to know when the battery has reached its storage capacity. If you have a volt meter, the battery is at full capacity when it reaches 12.6 volts with the charger disconnected from the battery. Alternately, you can purchase a battery tester, very similar to an anti-freeze tester, which checks the specific gravity of the acid in the battery. Those can be purchased at any auto parts store for a couple dollars. You must have a battery with removable cell covers to test the fluid, most all lawn tractor batteries have removable covers. As a side note, ensure each cell has enough "water" to cover the lead plates by 1/4 of an inch or so.


Can you use a 6V 2amp adapter on a 6V 600mA device?

No. You need to use the exact battery charger for the battery specified by the manufacturer, in order to achieve the correct charge cutoff point. In particular NiCad and similar batteries detect full charge by detecting the knee point in voltage per unit time given a specific charge current. Using the wrong charger could result in overcharge which will damage the battery.


Slow charge vs fast charge for 12 volt car batteries?

Most battery chargers offer two different rates of charge. The slow rate is 2amps, and the fast rate is 6amps or 10amps, depending on the charger. It is always better for the battery, and safer for the owner, to charge at the 2 amp rate. It produces less heat and stress on the battery, and will help it last longer. The only downside is that it will take 8-10 hours (or overnight) to bring the battery to a full charge. The more rapid rate of charge will recharge a battery in just two hours. If you need a more rapid rate of charge than overnight (maybe you need your car to start ASAP), then it is OK to use the rapid rate on your battery charger but there are important safety precautions. The higher amps necessary for rapid charge heats up the battery, which shortens battery life. It also causes more gas to form in the liquid (acid) in the battery. This gas is hydrogen, and is highly explosive. Hydrogen gas can build up enough pressure to swell or explode the battery, which is extremely dangerous. Acid can spew all over the place and cause bad burns. To avoid this, the six cell-caps on top of the battery have vents in them to let the gas out, but rapid rates of charge may produce more gas than the vents can cope with. Thus it is much safer to unscrew or lever off the caps(depending on the type of battery), and set them loosely over the holes. This lets the pressure out, but keeps debris from falling into the interior of the battery. Secondly, and equally important, you must avoid open flames or sparks, which might ignite the hydrogen gas. In an enclosed space, turning on an electric light or switch can be enough to cause an explosion . Charging the battery outdoors is safer than indoors, but if the garage door is left open to provide good air flow, it is fairly safe. In conclusion, the slower 2amp rate of charge is easier on the battery and safer for yourself, but takes overnight. The rapid rate (6 or 10amp) is fairly safe if suitable safety precautions are taken.


2amp work with 3 amp power?

you haven't asked a question