Yes, if it is a sensor that goes into the block.
the seal on the crank shaft needs replaced
crank shaft sensor is near the oil filter. I have the repair manual but I am unable to past the page in here.
The crank shaft sensor on a 2000 Chevy Suburban is located on the bottom of the engine, near the oil filter. It constantly monitors the crank shaft and updates the vehicle's computer of its status.
NO it will not. They have NOTHING to do with oil usage.
DOWN BY THE OIL FILTER EASY TO DO
To much oil (if it's industrial) or broken oil seal on top crank shaft
The crank shaft position sensor is just above the oil filter at the tail end of the starter
The crankshaft sensor is on the side of the engine behind the alternator. It is mounted close to the oil filter,
can a knock sensor leak oil for 305
It is in the oil pan. Nissan has had a recall to reprogram the sensor. They may have to replace the sensor for free. It cost about $600 for repair.
GET A NEW CAR AND GIVE ME 5 BUCKS
There are several sensors on a 1995 Neon. The water temp sensor, crank shaft position sensor, and oil temp sensor are all mounted at various places on the engine block.