Yes. Bad wiring can make any fuse blow
The Dodge Dynasty was produced from the years 1988 to 1993. The wiring harness from the fuel pump to the battery in a 1989 Dodge Dynasty is located very close to the battery terminals.
Probably a bad fuel pump. Disconnect the wiring harness at the fuel pump and put in a new fuse. If it doesn't blow and you have 12 volts at the pump with the key on, replace the pump. If your fuse still blows, you have a short in the wiring somewhere.
The term "harness" refers to the wiring loom. The fuel pump harness would be the wiring to the fuel pump assembly. That wiring would be part of a much greater wiring loom, that would run along the frame rail, and immerge under the hood to become part of the main engine control wiring harness assembly, which includes all the wiring to all the engine sensors and solenoids, and even runs to the computer. You can locate one end of the harness where the connector plugs into the fuel pump on top of the fuel tank. It will go from there, and pretty much run the length of the car, spidering out under the hood, and going just about everywhere. There may be a connector or connectors that separate the rear body and fuel pump harness from the rest of the vehicle harnesses, but don't count on it.
My 1994 had the same problem I had removed the tank to fix a rusted fuel line and pinched the wiring harness when I reinstalled it or maybe the fuel pump is headed south hope this helps
check engine wiring harness where it runs across top of transmission for rubing and short to ground
NO. The computer and the wireing harness is different and so is the fuel pump / pressure.
Remove the fuel regulator retaining screws. Remove the fuel regulator wiring harness. Reverse the process to install the new fuel regulator.
Sometimes you do. If the new fuel pump came with a substitute harness you will need to. The reason is that a change has occurred possibly due to a recall and the old harness won't fit the replacement pump.
Engine wiring harness is primarily used to control fuel and ignition timing. Switches, sensors and actuators are also some of the other components that are related to vehicle engine control.
The fuel pump is in the gas tank if it is bad i recommend replacing the wiring harness that is connected to the top of the fuel pump.
The fuel pump or the wiring is shorted to ground.
Hi I have a 2005 3010 transmule and it is in the shop right now needing a wiring harness. They put on 3 new fuel pumps and it burned them up. I wish you luck, they want $1,100 to put in a new wiring harness.