This rarely happens, but yes it can. If you buy plugs with the wrong gap it will cause an insufficient burn or even misfiring. Normally, this seems as though it is just a coincidence. You should check for gas leaks when ever possible.
why do my spark plugs smell like gas but the conductor is dry just the threads smell like gas and are also wet
Like most cars with no "spark" it can be caused by faulty/old cables. Replacing them would be a quick and cheap solution if in fact they are the cause.
If your Explorer has ac, you have to remove the passenger side front wheel and then the wheel well flap. The job of replacing the spark plugs will then be much easier. Sounds like a lot of trouble, but well worth it.
if oil is getting into spark plugs, this indicates that either the valve stem seals need replacing,or the oil rings on pistons are worn and need replacing. if valve stem seals are the problem ,the vehicle will really be blowing a lot of exhaust smoke to the extent sometimes that it will look like a smoke screen behind you
Yes, bad spark plugs can cause a 2000 Dodge Intrepid to smell like gas. When spark plugs fail, they may not ignite the fuel-air mixture properly, leading to unburned fuel being expelled into the exhaust system. This can result in a strong gasoline odor, especially when the engine is running. Additionally, poor combustion can lead to increased fuel consumption and potential engine performance issues.
Like any car it depends on how many cylinders the car has. If it is a 4 cylinder then it has 4 spark plugs. If it's a 6 cylinder it has 6 spark plugs. An 8 cylinder truck has 8 spark plugs
Pull the wires out of the top of the motor, they have a long plastic boot on the end of the wire. Using a spark plug socket and a long extension you will be able to remove the spark plugs. Check the gap on your new plugs and I like to use a section of hose that fits on the top of the spark plug to to thread the plug back in. That way you reduce the chance of cross threading. Once you get them started you can tighten them down. I usually replace the wires when I replace the plugs. I would suggest replacing the plugs/wires one at a time to reduce the risk of mixing the wires up.
To change the spark plugs on a Maruti Alto, first, make sure the car is turned off and parked safely. Find the spark plugs at the end of the rubber-like wires in the engine. Remove the wire from the spark plus, remove the old spark plugs, and put in the new ones, and replace the wires.
remove spark plugs dry them with a cloth put them back in crank the engine take them out again look to see if they re wet and smell like fuel
Take them out like any ordinary spark plug system.
I'm not a mechanic but it sounds like there has been a mixup involving your spark plug wires , either at the coil pack or at the spark plugs
Dirty spark plugs can occur on any make, model, or year. Changing the spark plugs should be done for maintenance, such as when you do a tune up.