answersLogoWhite

0

No. Codes are stored on non-volatile memory and clearing them requires a suitable fault code reader/scanner or computer with diagnostic software.

On some vehicles yes, others no.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How do you reset warning lights 95 Oldsmobile?

The check engine and other dash warning lights can be reset by disconnecting the vehicles battery for more then 5 minutes. If warning light continues after reconnecting battery then there is still a problem.


How do you reset the ABS and brake lights on a 2000 Toyota MR2?

To reset the ABS and brake lights on a 2002 Toyota MR2, trying disconnecting the battery for 10 minutes. A Toyota dealer can also reset the lights.


Your 94 buick lesabre will not start The battery is OK?

If you lights do not dim when turning key, then probably your starter.


What causes intermitent dashboard lights to flicker on Hyundai santa fe?

An elf under the hood who's disconnecting and re-connecting the battery terminals!


How do you replace fog lights in 2006 Mercedes CL500?

To replace the fog lights in a 2006 Mercedes CL500, start by turning off the vehicle and disconnecting the battery for safety. Remove the fog light assembly by accessing it through the wheel well or directly from under the front bumper, depending on your approach. Disconnect the electrical connector, then unscrew or unclip the old fog light and replace it with the new one. Finally, reassemble the fog light assembly, reconnect the battery, and test the new fog lights.


Why does your idle drop when you turn your driving lights on?

Turning the lights on put a load on the alternator causing the idle speed to drop. I would have the battery and charging system tested to make sure everything is okay. The battery may be on its way out.


Why turning ignition key causes flash of the dash board lights and make them dead immediately and no sound of the engine cranking?

When turning the ignition key, a flash of dashboard lights followed by them going dead usually indicates a weak or dead battery. The initial power surge activates the lights, but if the battery cannot sustain the load, the voltage drops, causing the lights to go out. Additionally, a faulty ignition switch, corroded battery terminals, or a malfunctioning starter can prevent the engine from cranking, resulting in no sound. It’s essential to check the battery and connections to diagnose the issue.


Brake lights drain battery on Nissan Quest?

Check switch under pedal & make sure is turning off when not applied.


How do you turn off fog lights on Acura MDX when it stays on after you turn the ignition key to off?

Well the most obvious and dangerous way of doing this is by disconnecting your battery cables and then connecting them again once the fog lights have turned off.


Is there a site that shows how to reset the warning lights on GM cars and trucks?

An easy way to do this is disconnect the battery for about 5 minutes and reconnect the battery. This should reset all warning lights. ----------------------------------- You need to either look in the owners manual or purchase a Haynes Manual to obtain the information you need. Disconnecting the battery is NOT a good idea as it is possible to get a voltage spike which can damage electronics.


How do you reset check engine light BMW z4?

The same as on all OBD-II compliant vehicles -- use a code reader's reset function. Disconnecting the battery is another way to reset check engine lights, but I do not recommend it on BMW's, as disconnecting the battery often messes with BMW's brains and require things such as the window functions to be reset/relearned.


When charging flat battery from other car why do you need to put your parks lights on?

Turning Parking Lights ON while Charging BatteryNO, it serves no purpose other than to reduce the life of the parking light bulb filaments, and to cause the battery to have to be charged longer.