answersLogoWhite

0

What else can I help you with?

Related Questions

What does a piston do in a combustion engine?

A piston is attached to a piston rod in a combustion engine. It compresses the air in the cylinder block and that air ignites when fuel is injected into the block, giving the car power.


What is piston and its function?

piston is a plunger that moves ups and down in the engine block.the function of the piston is to compress air mixtures in the engine block


Procedure to measure the size of piston engine block?

s4


How wide is a small block Chevy piston?

4in. wide


Can you replace just one cylinder in a 1999 ford ranger or do you have to change all of them?

When you say cylinder, you're talking about the space where the piston is. The cylinder is but one of four or six or eight in an engine block. You can't change one cylinder as it is part of the block. You would have to change the entire block or bore each cylinder to specifications equal to each for the engine to run proficiently.


Can you paste a piston facing up in Minecraft?

well it is very simple, Stand on The Block You want to place the piston on. Once that's done quickly jump and place the piston.


What kind of motor is a block?

a block is not a kind of motor, is is a piece of a motor. it is the part that the piston moves up and down in.


What is the clearance of piston ring to the block?

There is no clearance of the ring to the block. The ring works in contact with the block to seal the combustion chamber and provide oil control.


How do you change the piston-rings on a ford f100?

The pistons and connecting rods have to be disconnected from the crankshaft, then removed from the top of the engine block. The oil pan and heads will have to be removed to gain access.


What Locks up an engine?

Lack of water in you engine block. Lack of oil in your engine block. Can cause piston siege.


Will a 6 cly from 94 in a Jeep Grand Cherokee fit a 98?

The block is the same, everything else will need swapped.


Cylinder bore formula?

this is the diameter of the cylinder hole in the engine block for the piston