answersLogoWhite

0

Drilling out a broken valve stem is possible, but it requires precision to avoid damaging the valve seat or surrounding components. After drilling, you would need to tap the hole for a new valve stem or insert a suitable repair. It's essential to ensure that any debris from drilling is thoroughly cleaned out to prevent issues. If you're not experienced, it's advisable to consult a professional mechanic for this repair.

User Avatar

AnswerBot

2mo ago

What else can I help you with?

Related Questions

The valve blew off your pressure cooker can you replace it?

Depends. Did the threads tear out of the lid? If so, you could possibly drill it bigger, tap in new threads for an adapter and put a new valve in. Just checking, the gauge or the little rubber safety valve? If it is just the rubber safety plug, then yes, it should be possible to replace it. That's what it's there for.


What would cause the vacuum breaker on your geyser to leak?

A weak spring or broken valve seat. Just drain tank slightly and replace it,they are cheap and not worth fixing.


How do you replace the EGR valve on a 2002 Ford Mustang?

just unbolt the valve


How often to replace PCV valve on 2001 solara v6?

The PCV valve only needs replacement if broken or if it's so gummed up it isn't functioning. The part is so inexpensive (usually $5 or less) that it's hardly worth cleaning. Just remove and replace if you get a code indicating the valve has failed. Cheers


How do you get a broken drill bit out of a broken stud?

U don't u just gonna be sitting there crying u big baby. Haha haha.


How do you fix singing toilet?

Just replace the ballcock valve..


Can you clean the Idle Control Valve rather than buy a new one?

no just replace the valve


How do you replace PCV valve on 2005 impala?

There might not be one to replace? On the 2008 3.5L there is none, just a nipple on the valve cover. Double check to make sure.


How do you replace main water valve?

You turn off the water valve before it -probably on the sidewalk, or just on your front yard. Then remove the main valve and replace it. NOT a job for amateurs. I hope you have some experience at least.


How do you fix a broken truck dash?

the best way to fix a broken dash is to replace it. It's much easier ,and cheaper to just replace it, that's what i had to do. sorry.


What is a way to fix a broken reed?

sorry, you can't. you just have to replace it.


How often you need to replace the EGR valve?

No set time...just at failure