0
What else can I help you with?
Does fuse power door speakers on Mitsubishi eclipse 1998?
No. The radio or amp would be fused, but not the speakers.
Can you use a mono power amplifier to power speakers or aew they strictly for subwoofers?
Certainly, you can also use 2 mono amps to power left and right stereo channels. One for each channel. Using one mono amp for stereo results in a mono output though.
Is it bad to bridge 2 2ohm speakers on a mono or 2 channel amp?
Yup
Can you hook 2 subs to a mono amp?
Sure i have 2 400 watt rockfords connected to a 400watt kenwood mono amp. This statement made by another is true.You can hook up 20 subs to a mono amp; BUT you have to configure the speakers by impedance/ohms. if you hook two 2 ohm speakers to a 4 ohm steady amp in parallel you will soon buy a new amp. if you hook 10 speakers in series you will not even get it warm. Each speaker will also divide the available wattage and will not have a lot of power. Take it to a good shop if you don't know the formula for this. you may save your amp. BMyers Lake city, FL
Can 6 speakers be used in a Chevy Silverado?
Yes you can put 6 speakers in a silverado, by instaling a 4 chanels amp for the front, and mono amp 1 chanel for the sub
Can a 350 watt amp power 2 12s?
It depends on the power and impedance rating of the 12-inch speakers. If both speakers are rated for 175 watts and the amp can handle the impedance of the speakers, then the 350 watt amp should be able to power both speakers effectively.
How do you connect your speakers to your aftermarket amp in a jeep charokee amp?
The RCA's from the amp will be arn to the CD player, then you need to connect the speaker's wire to the output + and - of the amp, this will cause the amp to have musical power from your radio, and the speakers to have the power from the amp..-Shocker
Where is the amp for 1993 Lexus LS400 located?
there are amps behind the door speakers
2 door speakers do you need a 4 channel amp?
No that would be a 2 channel amp. 1 speaker per channel. 2 speakers= 2 channels 4 speakers= 4 channels
How does a mono amp work?
A mono amp, is half of a stereo amp. It has one input and one output.
Is a 4 channel amplifier better than a mono?
It all depends on what your using it for, in example. If you have a 400 watt 4 channel amplifier then that means you can hook up 4 units to the amplifier at a 100 watts each (4x100=400). these units could be things such as door speakers, tweeters, mid ranges, anything that produces sound. A mono is no better than 4 channel it is just used for a different purpose. Mono or Mono-block amplifiers are used for subwoofers because they only have one slot to exert power from so the whole power of the amp is distributed to one source. The cool thing about 4 channel amplifiers is that you can get some decent aftermarket door speakers and hook them up to your 4 channel, turn on your high pass frequency filter, and blast those speakers as loud as you want without having your bass drown them out.
Why would the amp radio in a 1996 Suburban not be working where the two front speakers are ok but the center two and rear two are not?
According to http://www.installdr.com/Harnesses/GM-Wiring.pdf the connector for the rear speakers is separate from the front speakers. If the connector for the rear speakers is loose or disconnected, the rear speakers would not work while the front ones will. The amp in the head unit (dashboard radio) powers the front door speakers. The rear door speakers and roof (pillar) speakers in the rear are powered by a second amp under the drivers seat. Either this amp is bad or is not hooked up.
