No. By using a higher amperage fuse, you allow more dangerous current to pass through the wires. The fuse would not be able to do its job: protecting the circuit.
Absolutely not. The fuse is there to protect the wiring. Installing a larger fuse than required will remove that protection and could cause a fire. You can go with a smaller fuse but never a larger fuse.
fuse number 1 is 10 amp fuse 2 is 25 amp fuse 3is 25 amp fuse 4 is a spare fuse 5 is 10 amp fuse 6 is a spare fuse 7 is 20 amp fuse 8 is 25 amp fuse 9 is 20 amp fuse 10 is 5 amp fuse 11 is 5 amp fuse 12 is a spare fuse 13 is 5 amp fuse 14 is 15 amp
20 amp body fuse 20 amp body fuse #15 on the fuse block 25 amp body feed fuse
It is not recommended to replace a 30 amp fuse with a 25 amp fuse in a central AC unit. The fuse should match the specified amperage requirements to prevent damage or overheating of the unit. Using a lower amp fuse could potentially lead to electrical issues or failure of the AC unit.
On a 1998 Ford Ranger ( fuse # 17 ) is a ( 25 amp ) fuse for the cigarette lighter
Yes you can but you are setting yourself up for a big problem. There is a reason the 20 amp fuse is blowing. By installing a bigger fuse it allows the current that is causing the 20 amp fuse to blow to stay in for a longer period of time. This can cause excessive heating and melting of the wires on the circuit that is blowing on a 20 amp fuse. Trace the wire and find the fault. Always use the manufacturer's recommended fuse sizing for your own protection.
Install the fuse that is required for the circuit.
yes there is a fuse that powers all these accessory's. check under the steering column for the fuse box and i believe its a 15 amp or a 25 amp fuse check and see if its blown
No, the fuse for the alternator on a 1998 Ford F-150 would not be a 25 amp. It would most likely be a 20 amp.?æ
front windshield wiper is in the fuse boxtitled wiper it takes a 25 amp fuse the rear wiper fuse is also the radio fuse 20 amp
You have to rewire the circuit completely with 10 AWG wire and replace all outlets and switches with devices rated at 25 Amps. Note 25 Amp breaker is an unusual size. 10 AWG will go up to 30 amps, and that would be the way to go.
25 AMP