answersLogoWhite

0

You must drop the gas tank down in order to remove the fuel pump and internal systems.

You can use a floor jack to support the tank as you loosen the strap bands.

Once the bands are free you can use the jack to slowly lower it down.

It is highly recommended to use or drain out as much of the fuel as you can before hand.

Please do not smoke or have open flames near or around the tank at any time.

There maybe a locking ring that you can use a flat head screwdriver to turn and remove.

Then the assembly should just twist or lift out.

Make the necessary disconnections for power and motor fuel feed line.

Hook the new one up and reverse the removal procedure.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you reset computer on 1995 Oldsmobile cutlass ciera?

can i reset it or replace it ,where is it on the car


How do you replace a starter on a 1995 Cutlass Ciera?

This is an interesting question! We've notified our experts in this category and we'll email you when there is a response.


Does Oldsmobile Cutlass Ciera 1995 have anti-lock breaks?

It has ABS.


Where is the unlock relay located on a 1995 Oldsmobile Cutlass Ciera?

The door lock/unlock relay is located behind the I/P on a 1995 Oldsmobile Cutlass Ciera. The relay is at the RH shroud just beside the center access hole


Where is the flasher for a 1995 Oldsmobile Cutlass Ciera wagon?

1995 Oldsmobile Cutlass Ciera turn signal flasher is behind the fuse panel. The 4-way flasher is to the right side of the glove box below the horn relay.


How do you remove the factory radio in a 1995 olds cutlass ciera?

go to BEST BUT and spend 69.99


Where can you download a free 1995 Cutlass Ciera Owner's Manual?

This will be included with your (nonfree) subscription to DealerWorld and SI.


How many liters of oil do you need for a 1995 Oldsmobile cutlass ciera sl?

4.5 or 4 1/2


Where is an alternator on 1995 Oldsmobile cutlass ciera?

On a 1995 Oldsmobile Cutlass Ciera, the alternator is located on the front of the engine, typically mounted near the top on the driver's side. It is driven by a belt connected to the crankshaft. To access it, you may need to remove the belt and possibly other components, depending on the specific engine configuration.


Reasons for poor idle quality of a 1995 olds cutlass ciera?

it's the idle control valve, $60 part, or the computer.


Why does the front end of your 1995 cutlass ciera vibrate?

Bad tire? Tires not balanced? Bent rim? Bad wheel bearing?


What is the firing order for a 1995 Oldsmobile cutlass ciera 3.1L?

The firing order for a 1995 Oldsmobile Cutlass Ciera with a 3.1L engine is 1-2-3-4-5-6. The cylinders are numbered from the front of the engine to the back, with cylinder 1 being the front driver's side. This firing order is standard for many GM V6 engines from that era.