Remove the positive cable from the battery post. Remove the cables from the alternator. Remove the alternator wiring harness. Remove the belt by loosening the tensioner pulley. Remove the alternator retaining bolts. Reverse the process to install the new alternator.
The 1999 Mazda 626 alternator is located on the right hand side of the engine. The alternator will be near the front of the engine.
It is built into the alternator...
Follow + battery cable should connect to solenoid
A 2001 Mazda 626 V6 - 4.2 quarts A 2001 Mazda 626 4 cylinder - 3.7 quarts
Remove passenger side Rack and pinion arm and slide out Alternator .
take it to a muffler shop
The positive battery terminal cable will always run to the alternator- just follow it down.
???????????? .....sdsds
It may be a bad new alternator or it was not connected properly. Have the alternator tested to see if it is actually good.
I Know 1993 have them them I have one and have replaced.
To release the alternator tension on a 1999 Mazda 626 V6, first, locate the tensioner pulley, which is typically near the alternator. Use a wrench or ratchet to rotate the tensioner pulley counterclockwise, which will loosen the serpentine belt. Once the tension is released, you can slide the belt off the alternator's pulley. Afterward, you can remove the alternator if needed.
try taking the bolt out for the motor mount on that side where alternator is and jacking the motor up.