0
Changing the length of a strut rod will alter the caster angle of a vehicle's suspension. A longer strut rod will typically increase the positive caster, while a shorter rod will decrease it. This adjustment can impact steering stability and self-centering characteristics of the vehicle. Proper caster settings are crucial for optimal handling and tire wear.
What else can I help you with?
Should you replace the strut mounts when changing the struts?
Yes, it is generally recommended to replace the strut mounts when changing the struts. Strut mounts can wear out over time and may contribute to noise, vibration, and poor handling if not replaced. Installing new mounts along with the struts ensures that the entire assembly functions optimally and can help extend the lifespan of the new struts.
Where is the 98 Volvo s70 camber located?
There is no factory adjustment for camber in the Volvo S70. Aftermarket camber adjustment kits are available which use a lobed bolt on one of the lower strut mount points to increase or decrease camber.
How do you adjust the camber on a 1997 grand prix?
You can buy what they refer to as camber bolts that you put where the strut mounts to the knuckle, which are oblong, and allow for adjustment. My alignment guy says they have a hard time getting them to work correctly and stay in place so the alternative is to elongate the lower mounting hole in the strut to allow adjustment. That would probably be the best way. When you buy aftermarket struts, they are usually already elongated.
How do you remove the front struts?
RemovalDisconnect the battery negative cable.Loosen the four strut mounting bolts in the engine compartment several turns. Do not remove yet.Place the vehicle on jack stands.Remove the front wheels.Remove the brake line from the clip on the front strut.At the bottom of the strut, there are two bolts which attach the front strut to the spindle assembly. The top bolt is an eccentric bolt which provides for adjustment of the wheel camber. Using a paint pen, scribe, or brightly colored nail polish, mark the orientation of the eccentric bolt to the strut.Remove the eccentric bolt and bottom retaining bolt from the bottom of the strut.Pull the strut away from the spindle until it is free from the bottom of the assembly.Hold the strut while removing the four mounting bolts at the top of the strut. Remove strut from the vehicle.If the strut is to be replaced, note the orientation of the eccentric bolt alignment mark from Step six and transfer that mark to the new strut
What is strut pressure?
pressure of a strut
Do strut assemblies come with strut mounts?
no
Replace struts on 2003 town and country?
You will need to compress the strut spring with a spring compressor. When the strut spring is compressed remove the strut retaining bolts. There is a strut retaining bolt on the top and the bottom of the strut assembly. Reverse the process to install the new strut.
Is there trick to removing the CV shafts on a 1991 Ford Escort?
There is no tricks, and no special tools. Just remember to dis-connect the strut at the lower ball joint- that way you won't mess up the camber adjustment.
What is the spanish word for car strut?
strut as in English
Does a donkey strut or trot?
donkeys trot not strut.
What is involved in changing the struts on a 2000 Honda accord?
Changing the struts on a 2000 Honda Accord requires removing the lower control arm, ball joint, and strut mounts. An alignment is suggested after installing new struts to provide the best drivability.
How To Replace VW Golf Hatch Strut?
Begin by compressing the strut spring with a spring compressor. Be very careful as the strut spring will be under hundreds of pounds of pressure. Remove the strut retaining bolts. Reverse the process to install your new strut.
