0
What else can I help you with?
How do you change oil cooler range rover p38?
To change the oil cooler on a Range Rover P38, first ensure the vehicle is safely elevated and supported. Drain the engine oil and coolant, then disconnect the oil cooler lines and remove the mounting bolts to take out the old cooler. Install the new oil cooler by reversing the removal process, ensuring all connections are secure and using new gaskets or seals if necessary. Finally, refill the engine oil and coolant, and check for leaks before starting the engine.
How to replace oil cooler seal on Chevy 350 v8?
Depending on where the leak is, if there is a weakness in the 350 it was with the oil cooler lines. It turns out that most of the oil leaks from the cooler lines has nothing to do with seals. It's a problem with the cooler line.
How many gaskets and seals does a 1998 dodge stratus have?
Dozens....
How do you change an oil cooler on a vw passat?
To change the oil cooler on a VW Passat, start by draining the engine oil and coolant to prevent spills. Remove any necessary components, such as the intake manifold or other obstructing parts, to access the oil cooler. Disconnect the oil lines and mounting bolts, then replace the old cooler with the new one, ensuring all seals are intact. Reassemble everything, refill the oil and coolant, and check for leaks before starting the engine.
How do you repair trans leak in 99 slk 230?
To repair a transmission leak in a 1999 SLK 230, first identify the source of the leak, which could be from the transmission pan, seals, or cooler lines. Clean the area around the leak and replace any damaged seals or gaskets. If the leak is from the transmission pan, consider tightening the bolts or replacing the pan if it's cracked. After repairs, refill the transmission fluid to the proper level and check for leaks again.
Will your 1972 Oldsmobile 442 run on ethanol?
Not without some serious mods to the carb, fuel lines, seals, gaskets, etc. E85 will eat through rubber in no time and will really dry stuff out.
What are rubber gaskets used for?
Rubber gaskets are used as seals between two objects, like a lid to a jar. Usually, rubber gaskets are used to prevent something from leaking. http://en.wikipedia.org/wiki/Gasket
Does the front seal go over the gaskets when insalling a new oil pan?
The seals go on first, then the tabs on the ends of the gaskets lay in the channels molded into the seals. A little dab of RTV sealant on each corner helps to avoid leaks.
Cant figure out if your 1996 jaguar van den plas has coil gaskets or valve cover spark plug seals?
Jaguars have plug seals.
Why do I smell gas when you fill the VW Vanagon gas tank?
The seals and gaskets on your gas tank are aging OR you have a crack or microfissure in your filler gas filler neck OR gasket and lines for overflow gas reservoir are cracked and aging.
Does Lucas Engine Oil Stop Leak work?
The effectiveness of automotive leak inhibitors vary dependent to the level of damage/degradation of the engine, transmission, cooling, and steering systems seals and gaskets. Engine oil stop leaks seal to recondition seals. Severely degraded seals and gaskets usually require replacement.
How do you remove Mazda rx8 radiator?
To remove the radiator from a Mazda RX-8, start by draining the coolant and disconnecting the battery. Next, remove the upper and lower radiator hoses, as well as any electrical connectors and the transmission cooler lines if equipped. Unbolt the radiator from its mounting brackets and carefully lift it out of the engine bay. Ensure to replace any worn seals or gaskets during reinstallation.
