answersLogoWhite

0

Do you need the engine to be running when adding transmission fluid to a 1995 Ford aerostar

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Do you keep your car running when adding antifreeze?

( NO ) with the engine cool


Can a 1994 areostar van all wheel drive with a 4 liter engine and automatic transmission tow a small camp trailer?

I tow with mine and I have over 150,000 trouble free miles.


How do I check my 1995 Corolla transmission oil level?

Answer There is a dip stick at the back of the engine. Start your engine first, let it run and check your transmission oil level. You only check transmission oil levels when the engine is running, other oil levels have to be checked when the engine is warm to hot but not running.


Is it bad for an automatic transmission car to be left in idle?

No, as long as the engine is not running hot it will not bother the transmission.


Should the engine be cool or running when adding antifreeze?

Your engine should be cold ( to be on the safe side) when adding antifreeze/coolant. i let the car sit overnight and then add it.


Where do i fill my transmission fluid in Grand Am?

The transmission fluid in an automatic transmission is added through the same tube that the dipstick sits in. For adding fluid, it is best to purchase a long-neck funnel, which is made just for this purpose. Be careful not to overfill the transmission. Always check the fluid level with the engine running, the transmission in either 'park' or 'neutral', and the vehicle on level ground.


How to check transmission fluid in 74 Chevy truck?

If you have an automatic transmission, check with the engine warm and running, The dip stick is located on the passenger side rear of the engine.


Do you check the transmission fluid level on a 1988 Olds Delta 88 with the engine stopped or running?

transmission fluid is checked with the car cooled off -never when running-(daddmac)


How do you add trans fluid to a 2003 Isuzu axiom?

To add transmission fluid to a 2003 Isuzu Axiom, first ensure the vehicle is parked on a level surface and the engine is running. Locate the transmission dipstick, usually found near the back of the engine bay, and remove it to check the fluid level. If low, use a funnel to add the appropriate type of transmission fluid through the dipstick tube, adding a little at a time and checking the level frequently. Be sure not to overfill, and after adding, run the engine briefly and recheck the fluid level for accuracy.


What kind of transmission fluid goes in 1998 Mazda 626?

Checking and adding Tranny fluid.There is a dipstick for the transmission fluid on all automatic transmissions, which is separate from the engine oil dipstick. The tube the dipstick sits in is the only place where fluid can be added. You will probably need the funnel with the really long, skinny neck, to be able to get the fluid into the tube. Be careful not to overfill the transmission, and be sure that you have the right kind of transmission fluid. The automatic transmission fluid level should be checked with the engine running, the transmission in Park or Neutral, and on a level surface. DO NOT PUT ENGINE OIL IN THE AUTOMATIC TRANSMISSION!


Does the car need to be running when adding antifreeze?

No , it's best to add coolant when the engine is cold


Where do you put the transmission fluid in a 2005 4Runner?

To add transmission fluid to a 2005 Toyota 4Runner, locate the transmission dipstick tube, which is usually found near the back of the engine compartment. Remove the dipstick, use a funnel to add the appropriate type of transmission fluid, and ensure you check the fluid level with the dipstick after adding. It's important to do this with the engine running and the transmission in park for accurate measurements. Always refer to the owner's manual for specific fluid specifications and recommendations.