To add Transmission Fluid to a 2003 Isuzu Axiom, first ensure the vehicle is parked on a level surface and the engine is running. Locate the transmission dipstick, usually found near the back of the engine bay, and remove it to check the fluid level. If low, use a funnel to add the appropriate type of transmission fluid through the dipstick tube, adding a little at a time and checking the level frequently. Be sure not to overfill, and after adding, run the engine briefly and recheck the fluid level for accuracy.
To check the automatic transmission fluid on a 2003 Isuzu Axiom, first ensure the vehicle is parked on a level surface and the engine is running. Locate the transmission dipstick, usually found near the back of the engine, and pull it out, wiping it clean. Reinsert the dipstick fully, then remove it again to check the fluid level; it should be between the "hot" marks if the engine is warm. Additionally, inspect the fluid's color and smell; it should be a bright red and not have a burnt odor.
Had the same problem with my 2003 Axiom... It was my intake gasket. 50 dollar gasket.... easy fix
Depends on what vehicle (make/model/year)
Rear top of transmission case near drive shaft output.
Yes.
No, the 2004 model features an Asin transmission as opposed to the GM transmission that was used in 2002-2003.
Perhaps disconnecting batt for 30 mins-but it will just come back on.
2003 izuzu anscender 6 cylinder
Need to remove a quart of trans. fluid to add a quart of lucas trans conditioner. Does not have a drain plug.
6.5 liters
there probably isn't one. Pontiac discontinued trans dipsticks in models earlier than yours. You have to check the fluid at the fill plug on the trans itself.
In most cases this info is stamped on the dipstick.