0
What else can I help you with?
What year did the geo prism use a 3 cylinder engine?
The Geo Metro was the only Geo to have a 3cylinder engine.
Who made the engine for the 1991 Geo Prism?
I believe Chevrolet
Is your 1994 geo prism a 1.6 or 1.8 engine?
1.6
How can you determine if you have a 1.6L engine or a 1.8L engine in your 1996 Geo Prism?
Answered by this question:Using the vin numbers to tell which model Geo Prizm you have?
Will a 1997 GEO Metro engine sohc interchange with a 1997 GEO Prizm dohc?
i dont think so.
Airbags Geo Prism?
Yes the Geo Prism has ait bags.
How to replace a starter for a 90 geo prism?
You gotta get under the car and do it from the back of the engine.
What kind of drive is a geo prism?
The Geo Prism is a compact car that was produced by General Motors under the Geo brand from 1989 to 1997. It is essentially a rebadged version of the Chevrolet Prizm, which was developed in partnership with Toyota. The Geo Prism typically features front-wheel drive and is known for its fuel efficiency and reliability. It was available with a range of four-cylinder engines during its production run.
How do you flush a radiator on a 1997 Geo Prism?
To flush the radiator on a 1997 Geo Prism, start by ensuring the engine is cool and then remove the radiator cap. Place a container under the radiator and open the drain valve at the bottom to let the old coolant drain out. After draining, close the valve, fill the radiator with a radiator flush solution and water, run the engine for about 10-15 minutes, then drain again. Finally, refill the radiator with the appropriate coolant mixture, and replace the cap.
How do you get to the starter on a1995 geo prism?
From under the car. It's on the backside of the engine between the engine and firewall. Just about smack in the middle.
Would a 1992 geo prism engine fit into a 1996 geo tracker to include the transmission?
No. The Prism motor is a Toyota motor and side mounted. The Tracker motor(suzuki) is mounted with the engine from front to back, so it will not work without a lot(I mean a lot) of work to do it.
Will a 95 geo prism enging with a 1.6 dohc engine fit into a geo storm with a 1.6 sohc including the transmission and what would i have to change?
it can be done but you will have to change all of ur wirring harness from the prism because the prism is basically a Toyota and a storm is a izuzu impulse knockoff
