0
What else can I help you with?
How do you align a cam sensor with a crank sensor on a pt cruiser?
If you are getting a code about cam/crank misalignment, you most likely have a problem with the timing belt. There is either a part failure or it is miss installed.Niether the cam or crank sensors have any adjustments.If you are getting a code about cam/crank misalignment, you most likely have a problem with the timing belt. There is either a part failure or it is miss installed.Niether the cam or crank sensors have any adjustments.
Would ethanol gasoline damage crank sensors on 2003 Nissan Altima crank sensors?
Should not. The crank sensor does not come in contact with the fuel nor the exhaust.
What happens when you install a 2005 motor in a 2002 jeep liberty?
The tone rings for the crank and cam position sensors are different and the engine will not run.The tone rings for the crank and cam position sensors are different and the engine will not run.
Where is the crank sensor located on a 2003 Grand am?
its been my experience , if its a 3.4lt, it has two sensors for the crank, one in the block. and one in front cover near crank.
What relays or sensors will cause 1992 olds98 not to start if you have fuel and spark?
possibly the crank angle or cam sensors Or injectors
Why would a 1995 Mark VIII not get fire at the coil packs?
check cam sensors and crank sensors. coils get their pulse from there
Geo Metro crank sensor location?
LOL, some dont have crank sensors my friend! if you dont have a crank sensor by your oil pan then you have a bad distributor sensor!
What is camshaft to crank shaft correlation 1999 tahoe 5.7?
That refers to engine timing. To set the timing on that year engine you MUST have a engine scanner to set the timing because it is computer controlled. A timing light will not work. The cam and crank sensors MUST be in correlation with each other. You probley have a bad cam are crank sensor if you are having starting and running problems. Only if the engine code is camshaft to crankshaft correlation. If you have removed are moved the distributor in any way then that will also give you the same code. Just have the timing set to specs and clear the codes.
What causes a 1992 Buick 3800 LeSabre not to have spark after changing the F-Pump and crank sensors?
check the wiring goig to the crank sensors and check and see if you can adjust the gap on the outside sensor maybe its not properly connected
Where is the crank sensor on a Chevy Lumina Z34?
what year? and what size engine? crank sensors are in different locations based on year and engine size.
1988 mustang 5.0 liter how do i trouble shoot no power to fuel injectors I have spark but no power to the injectors....not getting any fuel and yes I have gas in the tank and the pump kicks 40psi?
Run a code test on the computer to see what codes show. Sensors like the crank and cam sensors will cause misfiring, and the code may show which one to check to start with.
What does diagnostic code 13 on a Lexus sc400 mean?
RPM signal. Can be cam position sensors. Common for the drivers side cam position sensor wires to get chaffed from contact from the drive belt when they are incorrectly routed. The other possibilities are the crank position sensor which is on the drivers side front of engine by the crank pulley inboard of the oil filter. Third could be an incorrectly installed timing belt that is off a tooth. Also check all wiring on the cam position sensors and crank position sensor. Those are the most common causes of code 13 on 92 SC400 OBD 1.
