answersLogoWhite

0

NO. Just ground the amp to the chassis try to make ground short as possable about 12 inches is plenty. BE SURE GROUND WIRE IS THE SAME GAGE AS THE POWER WIRE. If its an 8 ga. + then use 8 ga. for the ground.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you wire a dual voice coil to an amp?

If you want to run both coils,you have to wire the positive to positive and negative to negative on your sub,then run a wire from each plug to the amp. Positive to the positive side of the amp and negative to negative side of the amp,(you can run in bridge mode or stereo if your amp can handle the load)


Can you hook up subwoofers and amp to a factory stereo in a 1998 Toyota Camry?

No, you can't. It does not have such cable at all.


What chord do you need to plug your Alesis DM6 into an amp?

According to Alesis the DM6 has:Inputs: 1/8" stereo mix-in, 25-pin D-sub for cable snakeOutputs: 1/8" stereo master, 1/8" headphoneSo a 1/8" stereo to whatever you amp wants.


How do you convert 2 RCA jacks from stereo down to 2 RCA jacks to the amp?

How about a audio cable with two MALE RCA jacks on each end. If both units are not stereo, use a "Y" cord to convert stereo to mono.


Where is the factory stereo amp located on a 2007 Cadillac CTS?

Where is factory stereo amp located on a 2007 Cadillac cts


What is the difference between amp and amp chord?

An amp is the actual amp while an amp chord connects the instrument to the amp.


How does a amp work?

A mono amp, is half of a stereo amp. It has one input and one output.


Where do you hook up remote wire when using stock CD player?

the remote wire only needs a power source for the amp to turn on, so if u have a looped cable running from the remote input on the amp to the front of the car with a switch and then back to the power cable on the amp u can control when the amp is on just by turning the switch on or off. otherwise u will have to figure out which cable on the back of the stereo is switched power, or which cable only supplies power when the car is running. and that would require a wiring diagram.


How do you install an amp in a 1987 Grand Marquis?

Clarify....Are you talking about an AMP for a Stereo?


How does a mono amp work?

A mono amp, is half of a stereo amp. It has one input and one output.


How do you wire an amplifier to 2 subs?

Mono amp: hook up 2 wires to the positive speaker output, and 2 wires to the negative speaker output. Hook the positives up to the positive leads on the subs, and the negatives to the negatives. Stereo amp: one positive wire to each positive output on the amp, same with negative. Make sure you get corresponding positive and negative to each sub. Stereo amp running bridged (mono): It's normally the outter positive and negative leads, but refer to the manual. Wire same way as a mono amp, just use the bridge outputs. Mono or Bridged would be running 2 ohms if you are running single coil subs. Stereo would be 4 ohms. If you have a dual coil sub (such as Kicker Comp VR), you would want to run stereo because those subs run 2 ohm's stock do to the dual voice coils. Or 1 amp per sub unless you have a 1 ohm stable amp, which most likely you don't.


Where is the infinity amp location in a 97 grand caravan?

The 1997 Grand Caravan Infinity amp can be located behind the stereo system. The stereo system will need to be removed in order to access the amp.