Mostly you will see it bolted to the engine.
From the battery to frame directly under the battery box. From the frame to the engine at the motor mounts with a short ground cable. Usually on the drivers side.
The ground wire leads from the negative side of the battery and connects either to the engine block or to the frame of the automobile.
You can test the fuel pump by touching the positive wire on the positive post of the battery. You will need to ground the ground wire.
anywhere on the frame or body that is cleaned of paint and rust.
positive goes to the battery and negitive goes to a ground clamp on the frame..
Might be bad ignition switch?? Check the ground wire as well. Check and clean if corroded: The Ground strap/wire from the frame to the engine The small ground wire from the battery to the body The Ground wire from the battery to the engine.
you need to attach a wire to the steel frame of the turn table, maybe a screw that's into metal not plastic on the frame of body of the turntable. then connect the wire to the ground terminal on your amp, the terminal should be marked.
Check the ground wire to the battery, nad frame.
The battery ground wire runs from the battery to the engine block.
Use a jumper wire from the battery + (pos) terminal to the positive on the blower motor, and run a - (Ground) wire from ground on the motor, to chassis or frame.
Generally near the battery. The factory topically anchor the wires within reach of the body ground wire because it all goes in at once.
They are everywhere. from the battery to the engine from the battery to the frame from the header to the body from the engine to the body and on every device in the vehicle you will find one.