0
What else can I help you with?
Will bars intake manifold stop leak work on Oldsmobile Silhouette 3.4 engine?
You need to replace the manifold and use Felpro Gaskets.
What's the easiest way to change the Manifold Gaskets on a 1993 Chevy Caprice Classic with a 5.7L V8 engine?
It is the Intake Manifold Gaskets FYIilikebananas
How do you repair exhaust manifold leak on a autoquest?
To repair an exhaust manifold leak on an Autoquest, first ensure the vehicle is safely elevated and secure. Remove the necessary components to access the exhaust manifold, then inspect it for cracks or damaged gaskets. Replace any faulty gaskets and, if needed, weld or replace the manifold itself. Reassemble all components, ensuring proper torque specifications are followed, and start the engine to check for any remaining leaks.
Oil leaking onto exhaust manifold Toyota Camry?
The oil leak is coming from the valve cover gasket and leaking onto the exhaust manifold, the rubber valve cover gaskets get hard from the engine heat and start to leak, you will have to replace the rubber valve cover gaskets to stop the oil leak
Where is knock sensor of gm savana van 2004 5.3L?
the knock sensors (there are 2 of them) are located under the intake manifold on the 5.3 engine,,,,,requires complete removal of manifold to replace.
Replace head gasket in 1997 buick 3.8 liter?
Head gaskets do not go bad on these. You need to replace the plastic upper intake manifold as it is leaking coolant into the combustion chamber. Common problem for this engine.
Will bars leak fix a intake manifold leak?
NO. That stuff will cause you more problems. You MUST replace the intake gaskets are you will wind up loosing the whole engine. OIL and engine coolant DON'T MIX.
How many hours it take to change manifold gasket in cutlaas car?
The year, engine size and if it is the intake manifold or an exhaust manifold gaskets would help.
How do you remove a inlet manifold on a Renault megane?
To remove the inlet manifold on a Renault Megane, first disconnect the battery and remove any necessary engine covers. Next, detach the intake air duct, electrical connectors, and vacuum lines connected to the manifold. Unscrew the bolts securing the manifold, and carefully lift it off the engine, ensuring not to damage any gaskets or attached components. Finally, clean the mating surfaces and replace any worn gaskets before reassembly.
Is it better to repair head gaskets or replace the engine?
if the miles on the engine aren't too high, then just replace the head gaskets. if the whole engine is tired go ahead and swap out the motor. its a lot cheaper to do the gaskets then to buy a new motor.
Where are the upper intake gaskets on a v6 2000 ford windstar?
The upper intake gaskets on a 2000 Ford Windstar V6 engine are located between the upper intake manifold and the lower intake manifold. To access them, you typically need to remove the upper intake manifold, which involves disconnecting various components like the throttle body, vacuum lines, and electrical connectors. Once the upper manifold is removed, you can replace the gaskets. It's advisable to follow a repair manual for specific steps and torque specifications.
How do you replace a Chevy Celebrity 2.8 L V6 intake manifold?
To replace the intake manifold on a Chevy Celebrity 2.8 L V6, first, disconnect the battery and remove any components obstructing access, such as the air cleaner and throttle body. Next, drain the coolant and remove the intake manifold bolts, carefully lifting off the manifold while ensuring the gaskets come off with it. Clean the surfaces of the engine block and install new gaskets before positioning the new manifold and tightening the bolts to the manufacturer’s specifications. Finally, reconnect all components, refill coolant, and check for leaks after starting the engine.
