replace the flasher fuse
if you mean: "why do hazard lights flash when brakes are on", then the answer is because vehicles are equipped with a hazard light relay that supercedes the brake lights. This way, slow moving vehicles can operate under hazard lighting.
you need to change the flasher can for the signal lights
1999 Audi a6 quattro, How I fix the problem when the turn signals don't blink, but hazard lights work well?
When both of the turn signals (indicators) of a car blink simultaneously, it is usually because the hazard lights are turned on.
Bad ground
That very well may be for the hazard switch. Try it and see if the lights blink when the button is depressed.
To determine if the hazard flash switch is bad in a 2001 Impala, check if the hazard lights activate when the switch is pressed. If the lights do not turn on or blink inconsistently, the switch may be faulty. Additionally, inspect the fuse related to the hazard lights; a blown fuse could also prevent the lights from working. If both the switch and fuse are functioning, further investigation into the wiring or relay may be needed.
try a new hazard switch. the power runs through this switch, and sounds as if it is burnt. Good luck.
Try checking & replacing turn signal flasher, which is usually located underdash by your left knee if your sitting in the drivers seat. Good Luck...
Doesn't have hazard lights.
It is the fuse for the hazard lights or as they are sometimes called, emergency lights.
On a 1999 GEO Tracker, a bad fuse can cause the headlights and dash lights to blink. A bad voltage regulator or alternator can also cause lights to blink and flicker.