answersLogoWhite

0

A simple test is to start the engine and let it run at idle. Connect a digital multimeter set to 20 volts DC to the battery. Red to + and black to -. If the alternator is good you will read from 13.5 to 15.5 volts. This tells you allot but is not a definitive test. To test it completely drive to your local auto parts store and have then test it under load. Most will do this for free.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Dodge avenger battery dead?

Charge it, replace it,test the alternator,Charge it, replace it,test the alternator,


How can you test the efficiency of a plan in management?

it is the activity that not do to work already that is the test efficiency a plan


How do test your alternator while in the car and the car will not start?

Car would either have to be running or alternator removed for bench test


How do you wire alternator to a battery to test alternator?

run it and then disconnect the negative wire from the battery if alternator dies its bad.


How do i test a 24 volt alternator?

with a voltmeter


How do you test alternator in 2002 S10 pickup?

Either drive to your local auto parts store and have them test it in the vehicle or you can remove the alternator and take it to your local auto parts store and they can bench test it for you.


What is full-fielding?

Full fielding is a diagnostic test of the alternator You make the alternator work full out and measure the voltage and amperage output to test it against a published specification.


What can cause a battery light to come on when the battery and alternator both test good on a 1992 SC 400?

Battery light usually means alternator not charging. Most common solutions would be be a bad alternator, bad connection, or loose alternator belt. If the battery and alt test ok than check the connections to the alternator and battery.


Which is the maximum efficiency machine between Alternator and Transformer?

the efficiency of transformer is more than alternator, because 1- the alternator have friction and windage loss but in transformer this not occure. 2- in the alternator the flux leak is more than the transformer, because in case of alternator the flux move through the air which is dimagnet and in transformer flux move through silicon steel. 3- in the other hand alternator have dc compound generator for exciation (depend on other electric course 220volt) but in t/f is not need.


How do you know when to replace the alternator when not running?

The alternator must be running to test without disassembly. If you remove it, many auto part stores will test at no charge. One test is a voltage test. Start the engine and use a multimeter to check the voltage at the battery. It should read between 13.5 and 16 volts. Any less or more and the alternator is bad.


How you can test a alternator?

Ask your local auto parts store to do it.


2004 Honda Element stalls?

it could be your crank posistion senson or alternator failing get a dia and a load test on alternator