turn it off
The rear wiper switch is on the end of the turn signal arm. Look at the picture on the arm to see where off is.
To change the rear wiper motor on a Kia Sorento, first, ensure the vehicle is turned off and the rear wiper is in the "off" position. Remove the plastic cover from the rear wiper motor by unscrewing any fasteners and gently prying it off. Disconnect the electrical connector and unscrew the motor from its mounting. Replace it with the new motor, reattach the electrical connector, and secure the cover back in place.
The 2008 Kia Sorento wiper blade sizes are 24" drivers side, 18" passenger side and a 14" rear wiper. See sources and related links below for more information. Since there are over 22 different wiper arm attachments, do not buy wipers just by length only. Be sure to lookup exact wiper blade part numbers by vehicle make, model and year for the brand wiper you decide to purchase. This ensures correct length AND correct attachment.
The 2008 Kia Sorento takes a 24" drivers side, 18" passenger side and a 14" rear wiper. See sources and related links below for more information. Since there are over 22 different wiper arm attachments, do not buy wipers just by length only. Be sure to lookup exact wiper blade part numbers by vehicle make, model and year for the brand wiper you decide to purchase. This ensures correct length AND correct attachment.
Flip up the cover on the end of the arm and undo the 12 mm nut. Pry the arm off the wiper motor shaft and simply press new one on. Be careful to align the arm a little past the wiper arm rest and tighten.
push the wiper lever away from you. this washes the rear windscreen and starts the wiper. push the lever away from you again to stop the wiper.
On a 2005 Kia Sorento, the wiper relay is typically located in the fuse box. The main fuse box is found in the engine compartment, near the battery. You can also check the interior fuse box, which is usually located under the dashboard on the driver's side. For exact identification, refer to the vehicle's owner manual for the specific layout and diagram of the fuse box.
Because your model is gone, as are most models on Sorento. You can stop that problem once and for all (along with the fantastic light problems) with a new dynamo with an overpower filter. (Bosch is a good solution)
The wiper relay switch for the rear wiper on a Ford Fiesta will cause the wiper to stop at the exact location where it is shut off. A hole in a vacuum hose will also cause this to happen, but the wiper will also run intermittently if it were a vacuum hose problem.
CHECK THE FUSE FIRST. IF THE FUSE IS FINE, THEN YOU HAVE TO REPLACE THE WIPER MOTOR ITSELF
The rear wiper on a 1998 Pontiac Montana may not stop due to a faulty wiper relay, a malfunctioning wiper motor, or a short circuit in the wiring. Additionally, a stuck wiper switch can also keep the wiper activated. Inspecting the wiring and testing the relay and motor can help identify the issue. If needed, replacing the faulty component should resolve the problem.
To replace the back wiper on a Renault Megane, first lift the wiper arm away from the rear window. Press the release tab on the wiper blade holder to detach the old blade. Align the new wiper blade with the holder and push it into place until you hear a click. Finally, lower the wiper arm back onto the window, ensuring it sits properly.
See the discussion page for amplifying information. Pull the wiper stalk toward you, the wiper should stop.