To replace the back wiper on a Renault Megane, first lift the wiper arm away from the rear window. Press the release tab on the wiper blade holder to detach the old blade. Align the new wiper blade with the holder and push it into place until you hear a click. Finally, lower the wiper arm back onto the window, ensuring it sits properly.
under the exhaust. Silly answer above, it's not. It will be at the back of the engine compartment close to the wipers.
at the back
13cm front and back
4 parking sensors on the back
To replace the windshield wipers on a 2003 Renault Clio, first lift the wiper arms away from the windshield. Then, locate the small tab on the wiper blade connector and press it to release the old blade. Slide the new wiper blade into the connector until it clicks into place. Finally, lower the wiper arms back onto the windshield, ensuring everything is secure.
6.5 Inch/165mm are a straight fit, unsure on the back
hello can anyone please tell me about the renault megane 1.9 tci the front passenger seat will not go down it gos back and forward but dos not go do at all hope u can help thank you
It is on the top righthand side at the back of the engine compartment.
About £35 if you buy an after market part. A lot more from a Renault dealer.
Good morning all, l have a 54 megane 1.9 dci how do l replace the heater back light. Cheers. George.
To change the bulb on a Renault Megane heater control, first, ensure the vehicle is off and disconnect the battery. Remove the trim panel surrounding the heater control, then carefully detach the control unit from the dashboard. Locate the bulb holder at the back of the unit, twist it to remove, and replace the old bulb with a new one. Reassemble the control unit and trim panel, then reconnect the battery to test the new bulb.
It is easiest to replace the back wiper blade by carefully prying off the cap at the bottom of the wiper and then remove the whole wiper arm. After that you will be able to easily replace the wiper blade per the instructions given by the wiper blade manufacturer. Once you have done that, simply reattach the arm and snap the cap back in place. This process will take you less than five minutes.