First you need to remove the AC belt to be able to install the alternator belt.
This can be accomplished by loosening the hinge bolt and set bolt on the side. Then adjust the tensioner bolt till you can slip the AC belt off.
Then you need to loosen the alternator hinge bolt and the set bolt on the side. Then adjust the tensioner bolt to the point where you can put the new alternator belt on to the main drive pulley, water pump and alternator pulleys. Then tighten the tensioner bolt till the belt has about 1/2 of give in the middle of the belt. Once in place tighten the set belt and hinge bolt.
Repeat the same process for putting the AC belt back on.
***I have replaced my alternator belt 4 times in the last two years and need to install it for the 5th time. I just found out that there is a consistent issue with Protoges and aftermarket alternator belts and proper fit. Save your self the time of doing this job over and over again and buy the OEM belt from your Mazda dealer.***
how do u replace alternator belt on 2002 mazda protege 5 stationwagon
The alternator is located on the back of the engine near the firewall (and windshield) on the passenger side, down near the bottom.
Yes they will fit. There is not a difference in part number for a protege or protege5.
Where is the igniyion coil on a2002 mazda protege
Mazda recommends that the belt be replaced every 105k.
in your face :)
no it will not fit.it is not the same lenght and the same height
The pulse generator on a 2002 Mazda Protege is located on the top of the transmission. The pulse generator can be purchased at any auto parts store such as NAPA.
does a 2002 mazda protege have a front wheel drive
For a 2002 Mazda Protege 5, the recommended oil is a 10w 30. 5w30 is recommended in temps below 30 degrees f.
I just replaced my fan belts on a 2002 Mazda Protege. It came out to a little over $200. I took my car to a Mazda dealership.
5X114.3