To change the battery on a 2000 Oldsmobile Silhouette, first, ensure the vehicle is off and parked on a level surface. Open the hood and locate the battery; then, disconnect the negative (-) terminal first, followed by the positive (+) terminal. Remove any securing brackets or clamps, lift the old battery out, and place the new one in its position. Finally, reconnect the positive terminal first, followed by the negative terminal, and ensure everything is secure before closing the hood.
what heads will fit on my 2000 olds silhouette v6 3.4
I have a olds silhouette. The battery is located on the right side of the engine( that is from the right side if you are sitting in the driver set) the battery is under thefuse box.
My 2000 uses 134A and looks stock...
all the messages are showing up on my 2000 olds silhoutte, why does it do this
To change the map sensor on a 2000 Olds Silhouette, first, locate the sensor, which is typically found on the intake manifold. Disconnect the electrical connector and remove the mounting screws holding the sensor in place. Replace it with the new sensor, secure it with the screws, and reconnect the electrical connector. Finally, ensure everything is properly connected before starting the vehicle to check for any issues.
Remove the alternator belt on your 2000 Oldsmobile. Disconnect the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Put the new alternator on and reverse the process.
There are two Fuse locations on the Silhouette. One under the hood, top left corner- the box with the battery cable connected to it, where the turn signal relay should be, OR in the fuse panel, between passenger side door and the dash. Good Luck.
Gm vehicles do not use inertia/reset switches.
1-2-3-4-5-6 Click the link for a diagram.
Crawl under the car and look up at the exhaust system. You will see the converter.
read my answer to reseting engine codes below...2001 olds silhouette..
how to get the interior lights to turn on on 2003 oldsmobile silhouette