To change the bumper on a 1997 Dodge van, first, safely lift the vehicle using jack stands and remove any necessary undercarriage components for access. Next, unbolt the old bumper from the mounting brackets, usually located at the corners and in the center. Align the new bumper with the brackets, securing it with the bolts, and ensure it is properly aligned. Finally, reattach any removed components and lower the vehicle back to the ground.
Is it a mini-van, or van? If it's a mini-van, definitely not, and im not to sure about the full-sized van, the bumpers are way different, but the mounts might be the same. Either way it will look incredibly stupid, because they are different.
no
Take it to a hitch shop. Most are welded on.
A 1997 Dodge Ram doesn't have a EGR valve.
A Dodge Ram Van.
No.
To remove the front bumper on a 1997 Ford E-150 van, first, disconnect the negative battery cable for safety. Then, remove the screws or bolts securing the bumper to the frame and any clips or fasteners on the sides. Carefully pull the bumper away from the van, taking care not to damage any attached wiring or components. Finally, lift the bumper off the mounting brackets to complete the removal.
A 1997 Ram does not have EGR.
it is under the van close to the gas tank
You should change the oil every 3000 miles in as 1994 Dodge Van.
how to replace the fuel pression regulator for a dodge ram 2500 1997 van.
I'd like to know the same answer for a 1997 Dodge ram van 2500!!