answersLogoWhite

0

Not too bad. Remove the line from it. Remove the bolts holding it on. remove the clip under the dash that attaches it to the pedal. It will come out. Reverse the order to install the new unit. Take the bleeder screw loose for the slave cylinder. Loose, not all the way out. Add fluid. If you wait and keep it full, gravity will bleed it for you. If not, pump the clutch pedal several times and hold it down. Loosen the bleeder screw at the slave cylinder. Air and fluid will come out. Keep doing that until the pedal is firm and nothing but fluid comes out. That's it. Good luck.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Where do clutch fluid goes in a Ford Escort?

Clutch master cylinder, usually located near the brake master cylinder. ------------------------------------------------------------------------------------------------ I chose the ( 1996 and 2003 ) Ford Escort owners manuals to look at and they show that the brake master cylinder is also used for the hydraulic clutch


How do you remove the clutch master cylinder f250 7.3 super duty diesel?

To remove the clutch master cylinder on a 1999-2003 Ford F250 7.3 Super Duty Diesel, first, disconnect the negative battery cable. Then, remove the clutch fluid reservoir cap and disconnect the hydraulic line from the master cylinder. Next, unbolt the master cylinder from the firewall and carefully pull it out, ensuring to minimize fluid spillage. Finally, install the new master cylinder by reversing the removal steps, making sure to bleed the system of air afterward.


How do you adjust a hydraulic clutch 2003 dodge diesel 3500 6 speed?

There are no adjustments on a HYDRAULIC CLUTCH SYSTEM. The clutch disc is ether worn out, or the clutch slave cylinder is going bad. Is the clutch master cylinder full of fluid ?? If not there is a leak in the system, and you are not depressing the throw out bearing far enough. and that makes it hard to shift.


Just replaced clutch in 2003 Hyundai Tiburon Clutch pedal will not go to floor to disengage clutch or work neutral safety switch Help?

It sounds as if the clevis connector for the clutch master cylinder may be incorrectly adjusted too far out. Removing the cotter retaining pin and the pin that attaches the clevis to the clutch pedal and turning the adjustment nut to shorten the clutch 'travel' should fix the problem. (or if you had a shop do the clutch replacement, bring it back to the shop and have them correctly adjust the clutch master cylinder travel) Hope this helps


What can be the problems can not change gears or anything 2003 alero clutch goes to floor and stays?

broken clutch cable could also be a shot slave cylinder...this will cause the clutch pedal to not come back up.


Where is the Clutch slave cylinder on my 2003 cavalier?

its right in the transmission


How much time does it take a professional to change the clutch in a kia optima 2003?

7.4 hours if this is the four cylinder more to turn the flywheel


Where is the master cylinder on 2003 Honda Odyssey?

Hi The master cylinder in the odyssey is where the break fluid tank it located under the tank


How much should it cost to replace a master cylinder 2003 Ford Taurus?

$300 and change at the Rainbow muffler and brake shop, Largo Florida


Where is the clutch slave cylinder on Chevy 2003 cavalier?

Inside the bell housing, the transmission has to come out


How do you adjust clutch on 2003 GTI?

It's a hydraulic clutch so its self adjusting. If your having problems the clutch itself may be bad or your slave cylinder may be going bad.


Where is the brake fluid located on a 2003 Kia Spectra?

in the master cylinder resivore ; )