answersLogoWhite

0

To change the engine oil in a 2008 GMC Sierra, start by warming up the engine slightly to help the oil drain more easily, then turn it off and let it cool for a few minutes. Place a drain pan under the oil pan, remove the drain plug with a wrench, and allow the old oil to fully drain out. Once drained, replace the drain plug, then remove the old oil filter using an oil filter wrench and install a new one, making sure to apply a bit of oil to the rubber gasket. Finally, pour in the new oil through the oil filler cap, using the recommended oil type and quantity, and check the oil level with the dipstick to ensure it's at the correct level.

User Avatar

AnswerBot

1d ago

What else can I help you with?

Related Questions

Where is the oil pan on a 2008 gmc sierra?

At the bottom of the engine block.


Where is oil pressure switch on 2008 Chevy sierra truck?

Need engine size.


How do you change oil on a 2008 star roadliner 1900cc?

howlong to change oil engine howlong to change oil geer


How many quarts of oil 2008 Lincoln navigator?

According to the 2008 Lincoln Navigator Owner Guide : With engine oil filter change : ( 7.0 quarts of engine oil )


How do you reset change engine oil for 2004 GMC sierra?

To reset the change engine oil light on a 2004 GMC Sierra, turn the ignition key to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. After this, the oil change light should turn off. If it remains on, you may need to repeat the process or check for other maintenance alerts.


Can a due oil change cause a engine light to come on in a 2008 grand caravan?

No, the oil change reminder and the check engine light are unrelated.


How many quarts for oil and filter change for 2008 town car?

According to the 2008 Lincoln Town Car Owner Guide : With engine oil filter change : ( 6.0 U.S. quarts of 5W-20 engine oil )


Change oil in 2008 Honda Pilot?

Is it required to change the crush washer on the engine oil pan drain plug


Where is the oil filter located on 2002 GMC sierra 43 engine truck?

On a 2002 GMC Sierra with a 4.3L engine, the oil filter is located on the driver's side of the engine, near the oil pan. It is positioned toward the rear of the engine compartment, making it somewhat accessible from underneath the truck. To change the oil filter, you may need to raise the vehicle for better access.


How many liters of oil does a 2007 GMC Sierra with 4.8L engine take?

A 2007 GMC Sierra with a 4.8L engine typically has an oil capacity of about 6 quarts, which is approximately 5.7 liters. This includes the oil filter change. Always refer to the owner's manual for the most accurate specifications and recommendations.


How much oil does a 2008 mustang V6 4.0 engine hold?

5 quarts ( 4.7 liters ) with engine oil filter change


How many quarts of oil does 2008 crown Victoria hold?

According to the 2008 Ford Crown Victoria Owner Guide : With engine oil filter change : ( 6.0 U.S. quarts of 5W-20 engine oil )