Your 1997 Mercury uses a spin on cartridge filter. The gasket is built into the filter. Just apply a thin layer of oil to the new filter gasket and screw it on. Tighten 3/4 turn after it makes contact with the mounting surface. Do not over tighten. If the old gasket was left on when you removed the old filter just pull it off.
To replace the gasket on the oil filter housing of a 1995 Mercury Grand Marquis, start by draining the engine oil and removing the oil filter. Next, locate the oil filter housing, unbolt it, and carefully remove it from the engine. Clean the mating surfaces thoroughly, then install a new gasket on the housing, reattach it, and torque the bolts to the manufacturer's specifications. Finally, replace the oil filter, refill the engine oil, and check for leaks.
The right tool's, and a new gasket.
Replace the gasket with a new one.
You have to drain the radiator, water goes to it, and remove the bolts, and remove the housing, a pain but take your time.
Change it
how to change a valve cover gasket on a 97 mercury grand marquis ?
Here are a few reasons for oil to spray from the filter area:The gasket from the old filter was stuck on the oil filter housing and was not removed before the new filter was installed.The new filters gasket is not seated correctly on the oil filter housing.No Oil filter gasket was installed with the new oil filter.Defective Oil Filter and/or Gasket.Oil Filter Housing came lose from the engine block or mounting surface.
Yes
There's a plastic guard on the underside of the car that must be removed so that you can get to the oil filter and drain plug. The filter itself is a canister filter, so you replace the paper filter and the rubber gasket, but reuse the plastic housing.
Remove the old filter and make sure you remove the old gasket, there should only be 1 gasket.
you drop the bottom fairing, exposing oil filter, using oil filter strap or pliers take off the old filter. wipe clean oil filter housing, lube gasket on new filter with new oil, spin on new filter, and tighten.
oil filters normally have a o ring or a d ring not a gasket. and it is installed on filter itself if you have the spin on type or around the filter cap / screw in housing if you have the cartridge type