answersLogoWhite

0

Inside the rear door entrance, next to the tail light assembly inside the opening of the van, you will see two Phillips head screws. Remove them and the tail light assembly will come off. The bulbs are accessed by turning counter clockwise, and pulling upwards on the light fixture assembly, found on the rear of the tail light assembly. These bulbs pop straight out of their sockets.When replacing the bulb and its' socket, note that there are different sized notches, so that it only goes in one way.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you change the rear turn signal on a 2002 Dodge Intrepid?

# Release decklid latch and open decklid. # Remove trunk lining from rear closure panel as necessary to gain access to tail lamp fasteners. # Remove nuts attaching tail lamp to rear closure panel. # Remove tail lamp from rear closure panel. # Remove socket(s) from tail lamp unit. # Pull lamp from socket.


How do you change the light bulb of the tail light of a Nissan Pathfinder?

# Remove rear combination lamp mounting bolts. # Pull rear combination lamp to remove from the vehicle. # Disconnect rear combination lamp connector. INSTALLATIONInstallation is in the reverse order of removal.


How do you change the rear tail light housing on a 2005 dodge caravan?

Open liftgate. Beside lamp housing are push pins. Pry them out while holding lamp in place so it won't fall out.


Where is the rear tail lamp failure module located on 2002 Lexus ls430?

5657439929222222220


How do you get to the rear brake light bulbs on a 1999 Nissan Frontier?

You have to unbolt the entire tail lamp assembly to change the bulbs. Unbolt the tail lamps from inside the corners of the bed, replace the light bulbs, bolt the tail lamps back in place.


How do you change the license plate light on a 1994 camaro?

Remove two rear lamp bolt/screws from rear license lamp. Remove lacense lamp from rear bumper fascia. Remove license lamp bulb and socket from rear license lamp. Replace bulb and install using reverse procedure.


What does fuse number 23 operate in a 2002 Jeep Liberty?

Rear lighting: Tail/Stop Lamp


How do you replace rear parking light lens on 1998 Dodge Dakota?

THERE IS NO PARKING LIGHT LENSE FOR THE REAR. IT'S ONLY THE TAIL LAMP ASSEMBLY!


How do you change a rear signal bulb on Mercury Mountaineer?

You first need to open the rear lift gate. Then you need to remove the two hex-head bolts from the side of the tail lamp using a socket wrench and 7 mm socket.


How do you replace a rear light bulb on daewoo matiz?

open the lift-gate and take off the tail lamp


How do you replace tail lamp assembly in Pontiac vibe?

To replace the tail lamp assembly in a Pontiac Vibe, first, open the rear hatch and locate the access panel or screws securing the tail lamp. Remove the screws or panel, then gently pull the tail lamp assembly away from the vehicle. Disconnect the electrical connector and replace the old assembly with the new one, reconnecting the electrical connector and securing it in place with screws. Finally, test the new tail lamp to ensure it functions properly before closing the access panel.


What bulb do you need for the rear blinker on a 2001 Ford Mustang?

According to the 2001 Ford Mustang Owner Guide : Tail lamp , Brake lamp , Turn lamp takes ( # 3157 K bulb )