To change the brake and clutch reservoir on a Peugeot 206, first ensure the vehicle is on a level surface and the engine is off. Remove the old reservoir by disconnecting the brake lines and any electrical connectors, then unbolt it from its mount. Install the new reservoir by securing it in place, reconnecting the brake lines and electrical connectors, and finally, refill with the appropriate brake fluid. Be sure to bleed the brake and clutch systems to remove any air before testing.
No pressure in clutch resevior, its next to the brake resevior, if its empty, put more, if not you have a leak.
Isnt one, its hydraulic, and its next to the brake fluid resevior
how to remove and fit rear brake shoes on a peugeot 206 1.1
there is too much in the container If you filled the resevior with brake fluid PRIOR to replacing any of the brake linings, it will cause the fluid to "backflow" into the resevior, thus it will overflow and leak from the cap.
A Big Hammmer or angle grinder
already changed brake switch but cant shift form P
change the wheel cylinders or the brake lines
In order to change the brake light switch in a Peugeot 307, you must dismantle and access the main light board on the dash and find the connecting switch, thusly flipping it back to the on position.
it depends on what model you have, the obvious place would be in the brake fluid resevior mounteing the servo.
You use the clutch to change gears or stop. Not necessary when slowing down.
can u show me where the brake fluid resevior on a 1998 bmw 528i is located
The clutch fluid on the manual transmission is actually shared with the brake system. Like each brake caliper, the clutch has its own bleed screw located between the engine and the firewall. Simply follow the same process for bleeding the brakes by purging the fluid starting with the rear brake calipers, then the clutch and lastly the front brake calipers.