Also, how do you repair, replace brake light bulb located at the bottom of rear window in the middle? Is there a fuse just for THAT circuit? Thanks, Mike Open trunk, look inside the trunk at where approximately the tailights are, look for plastic "wing-nut" style nuts, take them off (there are 3 I believe), work the tail light out from the outside. (you should be able to loosen it after the wingnuts are off with your hand) The wires will still be attached. They (the socket) will usually come out in a 1/4 turn, replace with indentical bulb.
Brake light, on your 2000 Chrysler Concorde, by accessing it from the inside of the trunk. Take hold of the brake light, push in and turn. The brake light will come out.
Dot 3
Parking brake not adjusted properly? Frozen brake caliper?
To change the brake pads on your 1999 Chrysler Concorde, start by safely lifting the vehicle and removing the wheel. Next, remove the caliper bolts and carefully slide the caliper off the rotor, taking care not to damage the brake line. Replace the old pads with new ones, ensuring they are properly seated, then reattach the caliper and secure it with the bolts. Finally, reassemble the wheel, lower the vehicle, and pump the brake pedal to ensure proper pad seating.
It is probably the brake lights that are on due to a misinstalled or damaged brake light switch.
You will need to use the universal brake lines sold at auto stores. You can check at a Chrysler dealer but I think they are discontinued there.
It plugs into the taillight.
The bleed screw is by the thermostat housing it looks like a brake bleed screw
I just replaced a blown third brake light bulb today. ... I have about 60k on my M and havent yet had to change the brake light---so if it only has to be done once in the ... If memory serves, the Concorde's is in the rear window. ... Well I decided to mod my 2004 300Mspecial Third Brake lights, not with a bulb ...
In the top of the trunk near where the brake light is located, there is a small plastic window, remove it and you access the light bulb.
check the brake light switch on the brake pedal
the turn signal/hazard flasher is located under the dash between the brake pedal and the fuse block.