0
I havewan 88. The taillight assembly must be taken off car.. This is what (rear part of the body comes off ) surrounds the lense. If I remember correctly their are 3 or 4 bolts holding the assembly. 2 or 3 Bolts are inside the trunk and one is underneath on the outsideof the vehicle. There may be rubber caps hiding the bolts. When all the bolts are off wiggle the assembly. If it wont move , better to makes sure no more bolts are holding it before excessive pressure used. Once this is taken off, the whole assembly will separate from the vehicle. Then unplug the light. The lense screws out from the inside and is pulled thru. I hope this helps and good luck.
What else can I help you with?
How do you change rear brake light on a 1989 Chevy truck?
Open the tail gate and look in at the side of the bed were the light lens is and you will see 2 small screws. Remove them and then pull the brake light lens out.
How do you change front side marker light on a Lincoln Ls?
The whole assembly snaps out. Pry the outside (rearmost) end of the lens out. Once its out the socket unscrews from the back of the lens and the lamp can be pulled out of the socket. It uses a #168 lamp.
How do you change the rear light lens on a 65 gto?
unbolt the light from inside the trunk and pull it out and then you will see how the lens comes out.
What is the ability to change the shape of the lens to bend light?
The ability to change the shape of the lens to bend light is called accommodation. This process allows the eye to focus on objects at different distances by adjusting the curvature of the lens.
How do you change light lens on a 2002 ford mustang?
You have to cange the whole light.
Is a periscope a concave lens?
No, a periscope uses mirrors to reflect light and change the direction of the image, not a concave lens which diverges light rays.
How do you change the Chevy Tracker tag light on 2001?
Both the lens and the light pull out.
How do you change a tail light on a 1988 Chevy Celebrity?
To change a tail light on a 1988 Celebrity: Open the trunk. Look on the back of the side light you want to change. There will be several 10 mm nuts. Remove the nut in the center of the tail light lens. It is usually silver. The lens will then pull out a bit, then there is a tab into the backup light, pull the lens out of that. You can then remove the light socket and replace the bulb.
How do you change the brake light in a 1996 Lincoln Continental?
pop the trunk and right behind where the lights are pull the carpet down and their will be either light sockets that twist and pull,or there will be plastic nuts,just unscrew and take the lens off
How does convex lens bend light?
A convex lens bends light by causing parallel rays of light to converge to a focal point after passing through the lens. This bending occurs due to the curvature of the lens surfaces, which causes light rays to refract or change direction as they pass through the lens. The degree of bending depends on the thickness and curvature of the lens.
How do you change the third brake light bulbs on a 1995 Chevy 2500?
Remove the two screws that hold the lens on, remove the lens and change the bulbs.
Why will a lens magnify?
This is related to a change in the direction of the light - this is called refraction.
