see CEL page
and BAD ECU PAGE.
here
world wide web dot kick-fix dot com (<dig?)
Suzuki Sidekick has a cable for the clutch. No fluid required. If it hard to push or seems to 'stick' then replace the cable.
Counter clockwise
I had this problem with my 95 sidekick. It was the fuel filter gone bad.
chances are in the glove box on the top right side. my 93 was wierd like that.
place the Diagnostic jumper and read out the flashes. http://www.kick-fix.com/CEL/CEL.html this looks complex but it covers 89 to 95 FED and California cars. then post your DTC errors here. code 12 is normal , but you will have others. http://www.suzuki-forums.com/suzuki-sidekick-escudo-vitara-geo-tracker/
there are 2 systems. in 1995 , the car was sold with both r12 and r134, different major parts. so are not interchangeable. 95 and back, but 94 and back can be. but 96-98 is a family. and are compatible. hope that helps. http://www.kick-fix.com/air-conditioning.html I am pretty sure it will, I know a '96 sidekick or tracker will fit. Most of the sidekick tracker stuff works. Check out the x90 yahoo group, very helfpul there.
http://www.kick-fix.com/CEL/CEL.html what year? above is 95 and older 96 and newer (all cars) needs a scan tool or code reader to see the error codes. The check engine lamps says, I have a DTC errors stored in memory. go get them.
To install the clutch cable on a 1995 Suzuki Sidekick JX 16 valve, start by disconnecting the old cable from the clutch pedal and the transmission. Route the new cable through the firewall and secure it to the clutch pedal assembly. Next, attach the cable to the clutch release lever on the transmission, ensuring it is properly adjusted for tension. Finally, check the clutch operation to ensure it engages and disengages smoothly.
No power to the ecm. Check the fuse marked ECM in the underhood fuse panel(located in the middle top of the firewall)
To change the starter on a 1995 Suzuki Sidekick, first disconnect the negative battery terminal to ensure safety. Remove the starter motor by unbolting it from the engine and disconnecting the electrical connections. Install the new starter by reversing the removal process, securing it properly, and reconnecting the battery. Finally, test the new starter to ensure it functions correctly.
IFF YOU MEAN THE PLUGS FOR THE ECU TO CHECK YOUR CODE IT IS LOCATED NEAR THE HOOD OPENRE ON TEH BOTTOM BEHIND THE TRIM
The ECM unit for a 95 S-10 Blazer is located under the hood on pass. side.. Right in the open.