answersLogoWhite

0

If you do not have an actual battery terminal cleaning tool (that you can pick up at any local autmotive related store), put water and baking soda on your battery terminals and take a rough grit sandpaper and give it a light sanding or use a wire brush if you have one.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Does car battery need to be maintained?

Keep the car battery surface clean. If you find a very solid oxide column appeared, should be promptly washed with hot irrigated, be removed, so as not to affect the pole and the continuity between the terminal. After clean up, wipe the surface of the battery clean terminal on the pole and butter, to ensure that the pole is not oxidized.


Can a car battery need a boost due to cold weather?

Yes. How old is the battery ? . Is it the correct battery for your car/truck Are the battery terminal connections loose or corroded ? Clean ,tighten Get the battery checked at a local garage ( load test )


How do you clean your car battery which has corrosion?

To clean a corroded car battery, first ensure the vehicle is turned off and disconnect the negative terminal followed by the positive terminal. Use a mixture of baking soda and water to neutralize the corrosion; apply it with a brush to the terminals and cable ends. Rinse with water and dry thoroughly, then reconnect the terminals, starting with the positive terminal first. Finally, consider applying a battery terminal protector or grease to prevent future corrosion.


Positive car battery terminal gets too hot to touch is that normal?

No, Remove the terminal and clean with wirebrush until both the clamp and battery post are shiny.Re-install.The heating problem should be eliminated.


What is red color on battery?

The red terminal on a car battery is the positive terminal which feeds electrical current to various devices. The black terminal is the negative, or ground, terminal which is attached to the car frame.


How do you install car battery?

Connect the terminal to the body of the car first, i.e. the nagative terminal, then connect the positive terminal.


Which terminal should you connect first when jump-starting a car battery?

When jump-starting a car battery, you should connect the positive terminal first.


Could a bad key switch cause the positive battery terminal to get hot?

No, the battery terminal should be able to handle as much electrical current as the vehicle should ever use, WITHOUT heating up. Clean or replace any battery terminal that is getting hot.


Your battery died and you put a new battery in your car and the car still does not turn on why?

Is there power to the starter "S" terminal? What car?


What do you attach negative lead to during jump start?

Connect the - cable from the negative battery terminal on the "live" battery to a clean bare metal part on the "dead" car. Make sure it wil not be touched when "dead" car starts


Charging a dead car battery?

To charge a dead car battery, you'll need a compatible battery charger or jumper cables and another vehicle with a working battery. If using a battery charger, connect the positive terminal of the charger to the dead battery’s positive terminal and the negative terminal to a grounded metal point on the car. If jump-starting, connect the positive terminals of both batteries first, followed by the negative terminal of the working battery to the dead battery's negative terminal. Allow the dead battery to charge for a sufficient time before attempting to start the vehicle.


Does car battery leak said post is broken?

Answer 1 - Leakage at a Battery Terminal PostNO, a leak at a battery terminal post does not usually indicate a broken post. Car battery terminal posts are very tough, and usually do not break, especially before the plastic battery case breaks. Usually, a leak around a car battery terminal post is caused by a failure of the SEAL of the case plastic cast around the terminal post. This can be caused by a manufacturing or material defect, from abuse, or from vibration.