answersLogoWhite

0

No, Remove the terminal and clean with wirebrush until both the clamp and battery post are shiny.Re-install.The heating problem should be eliminated.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How can you reset the ecu on a 2000 Kia Sephia?

Take the positive battery terminal loose and touch it to the negative terminal post for 30 seconds. Then put the positive terminal back on.


Can you touch a battery terminal safely?

No, it is not safe to touch a battery terminal as it can cause electric shock or burns.


Is it safe to touch the positive terminal of a car battery?

No, it is not safe to touch the positive terminal of a car battery as it can cause electric shock or burns due to the high voltage and current present. It is important to always handle car batteries with caution and use proper safety precautions.


How do you hook a car fan to the battery to see if it works?

If you have the fan removed from the car, you can just quickly use jumpers to connect the negative terminal of the fan to the negative terminal of the battery, then connect another jumper to the positive terminal of the fan,and with insulated hands(!) touch the other end to the positive terminal of the battery. If the fan runs, it's fine.


Can you touch the negative battery terminal safely?

No, it is not safe to touch the negative battery terminal as it can cause electric shock or injury.


Is it safe to touch the negative battery terminal?

No, it is not safe to touch the negative battery terminal as it can cause electric shock or injury.


How do you manually raise a power window?

Run a wire from the POSITIVE terminal on the battery and touch the red wire (positive) to the window motor and run another wire from the NEGATIVE terminal on the battery and touch the green wire (negative) to the window motor. The window should go down. Reverse the wires to make the window go up.


How can you tell which is positive and which is negative on a speaker hookup?

Depending on colours of course black is usually negative and the other colour (generally red but depends) is positive. Get a D-cell Battery. Now get two pieces of speaker wire. hold one wire on the positive terminal of the battery and hold the other on the negative side of the battery. touch the wires to the positive and negative posts on the speaker. if the cone moves out ward the positive and negative are correct if it moves inward then the positive and negative are reversed (out of phase.) this simple test will allow you to see which terminal is which. Get a D-cell Battery. Now get two pieces of speaker wire. Hold one wire on the positive terminal of the battery and hold the other on the negative side of the battery. Touch the wires to the positive and negative posts on the speaker. If the cone moves outward the positive and negative are correct if it moves inward then the positive and negative are reversed (out of phase.) this simple test will allow you to see which terminal is which.


How do you Manually raise a passenger power window?

Run a wire from the POSITIVE terminal on the battery and touch the red wire (positive) to the window motor and run another wire from the NEGATIVE terminal on the battery and touch the green wire (negative) to the window motor. The window should go down. Reverse the wires to make the window go up.


How do you reset the service engine light on your 1992 wrangler?

Disconnect the POSITIVE battery cable and touch it to the negative terminal OR disconnect the POSITIVE battery cable for about 30 minutes (either way drains the capacitors in the electrical system)


What could be draining the battery on a 1970 firebird?

It could be lights on in the trunk or a short someplace, your best bet would be to touch positive cable to the battery and if you get a spark something is drawing power from the battery, pull one fuse at a time and recheck the spark at the battery and when you have a fuse pulled and it finally doesn't spark when you touch the positive cable to the battery terminal you have found the circuit that your problem is in.


How do you test car horns?

touch the wires to the battery terminal