0
How do you connect an amp to a stock stereo so that the amp turns on and off with the car not wasting the battery?
DO NOT go putting wires into your fuse box, this could cause problems in the future, if you have a power Antenna wire on the back for your radio, [Blue in Most cars, but refer to your cars manual.] Splice the REMOTE wire from your amp into the Power antenna wire OR if you dont have a power antenna wire. if your car has RAP [Retained accessory power, or your radio doesnt turn off until you open a door] its a good idea to use a 12V Accessory wire. any more questions just email me.
Note : Many head units will only energize the power antenna wire when the radio is on and then deenergize it when you switch to cd. So your best bet is to just go with the accessory wire method described above.
What else can I help you with?
How do you install a stereo into a 1992 Chevy?
all I need is what the color codes from the stock wire harnes to connect to the new one
How do you replace the stock stereo unit on a 1996 Mazda mx6 LS?
To replace the stock stereo unit in a 1996 Mazda MX-6 LS, start by removing the trim panel surrounding the stereo using a flathead screwdriver or trim removal tool. Unscrew the mounting screws holding the stock stereo in place and gently pull it out. Disconnect the wiring harness and antenna cable from the back of the stereo. Finally, connect the new stereo to the wiring harness and antenna, secure it in place, and reattach the trim panel.
How do you remove the stock stereo from a 2000 Mazda MX-5 Miata?
To remove the stock stereo from a 2000 Mazda MX-5 Miata, first disconnect the negative battery cable to ensure safety. Next, gently pry off the plastic trim surrounding the stereo using a trim removal tool, then unscrew the screws securing the stereo in place. Carefully slide the stereo out and disconnect the wiring harness and antenna. Reverse the process for installation of a new stereo.
What is the Wattage of a stock stereo in a 1989 Acura Integra?
The wattage of your stock stereo in your 1989 Acura Integra is 75 watts. There was anÊoption for a larger stereo output of up to 200 watts.
Does a 1998 Chevrolet Cavalier have an auxiliary input jack?
it depends if u are using the stock stereo then no but if it is not a stock stereo then u may have an aux input jack which comes out the back of the stereo the easiest way is to just pull out the stereo and take a look
How do you connect a car stereo to an '88 Mercury Grand Marquis?
on mine i had a premium sound system package stock. i had to bypass the stock amp to run the head unit even though i am running it on the pre amp from the head unit. the speaker will notwork unless you bypass the the stock amp.
How do you remove the stock stereo from a 1990 Mazda Protege?
screwdriver, and then pull hard enough to rip out the wires and then there you have it. the way to remove a stock stereo the theft version
Where can you buy a new Keyless Entry Battery for 2007 Camry Hybrid?
To get any replacement battery for a keyless entry system you have 2 options, 1: Contact the dealer they carry these batterys in stock at most locations and 2: most aftermarket car stereo/security shops will have factory replacement batterys in stock
Can you hook up an mp to a stock stereo?
Yes you can. First, determine which type of signal input is required by your amplifier, RCA inputs or (+/-) speaker wire. If it's only RCA inputs and your stock stereo does not have RCA outputs in the rear of the unit, then you will have to convert each speaker wire pairs to RCA with a converter, then go to your amplifier. If your stock unit does have RCA out, then just use an RCA cable and connect the signal from your stereo to your amplifier. Then simply follow the instructions from your amplifier to connect your speakers depending on if they are 2ohm, 4ohm, or 8ohm, etc. PS - make sure you properly ground your amplifier to either chassis or directly to the negative on your battery. If you create any large amounts of resistance or have extra wire hanging around, you will get ground loops and EMI problems and hear engine noise from your speakers as you accelerate. Good Luck
Does a 2003 silverado have amp outputs on the stock stereo?
NO there is not.
How do you enter a stereo code on a 1994 Acura Vigor?
call the dealer, give them the vin number and tell them that you iether just purchased the car or had your battery changed and they will give you the stock code
How do I hook up an amp to a stock infiniti G35?
To hook up an amp to a stock Infiniti G35, start by disconnecting the car battery to ensure safety. Then, run a power wire from the battery to the amp's positive terminal, and connect a ground wire from the amp to a solid metal point on the car's chassis. Use RCA cables to connect the amp to the factory head unit, which may require a line-out converter if the stock system lacks RCA outputs. Finally, connect the speaker wires from the amp to your speakers, and recheck all connections before reconnecting the battery and testing the system.
