If the problem has been getting worse over time than it is your clutch. If was sudden, then it is your slave cylinder. Also, the slave cylinder will usuall leak fluid when it is bad. If your not sure and nobody else is either, replace the slave first. It is farely cheap and super easy to replace. I hope this helps and good luck!
In general they leak hydraulic brake fluid when they go bad.
After you have located the clutch slave cylinder, have someone depress the clutch pedal. You should see the piston of the slave cylinder extend somewhat. If it does not, either the slave cylinder is bad, or the master cylinder, or, there is not enough brake fluid in the system for it to operate properly. Check the level in the master cylinder. If the slave cylinder is leaking profusely, it is probably bad.
clamp the line to the slave cylinder and mash the clutch pedal. if the pedal gets hard to push,the slave is bad. if the clutch pedal goes down slowly with moderate pressure,the master cyl is bad clamp the line going to the slave cylinder. meant to say that in the previous answer
Bad clutch slave cylinder or failed soft hose from master to slave cylinder.
Usually if there is no indication of clutch wear, such as slippage, yet with the clutch completetly depressed it's hard to engage gears and the clutch engages very quckly
First you need to find out if your slave cylinder is leaking clutch fliud.check lines to slave cylinder from master clutch cylinder if no leaks most likely master clutch cylinder bad.
There is no adjustment on that year. You either have a worn out clutch disc or a bad clutch slave cylinder. Could be a bad clutch master cylinder too.
YOU CAN'T. The clutch is either worn out are the clutch slave cylinder is bad.
Does my 1995 Toyota Paseo have a clutch cable
my clutch is not working ..think the slave cylinder is bad ..135 , 000 miles ..
If we are talking about a clutch slave cylinder for a standard transmission, yes it could.
It is notadjustable, You either have a bad clutch slave cylinder, clutch master cylinder. The clutch and pressure plate may just be worn out.