You have a two year old hang on it until it breaks off, that's why I am looking for a replacement lid.
To remove the console lid in a 2007 Silverado LTZ, first open the console and locate the screws securing the lid—typically found under the felt lining. Use a Torx screwdriver to remove these screws. Once unscrewed, gently lift the lid off the hinge mechanism to detach it. Be careful not to force it, as this can damage the hinge or surrounding components.
Unbolt the entire console, something fell down in the front of the front console lid. then turn it over and whatever is jamming it should fall out.
Remove bolts on the underside of lid at the hinge. Remove screws on bottom side of the lid. Gently pry bottom of the lid from the top of the lid, there's a metal bracket in between them. The console lid should then be apart from the console.
In the 2004 Lexus RX330, the ashtray is located in the center console, just in front of the gear shift. It can be accessed by lifting the lid of the console compartment. Additionally, there is a second, smaller ashtray located in the rear of the center console for rear passengers.
Listed in your owners manual or on the drivers door post, trunk, glove box, or underside of console lid.
To remove the console from a 2004 Jeep Wrangler, start by lifting the center console lid and removing any screws located inside the storage compartment. Next, use a trim removal tool to carefully pry off any plastic trim pieces surrounding the console. Disconnect any electrical connectors if equipped, and then unscrew the mounting bolts securing the console to the floor. Finally, gently lift the console out of its position.
To remove the lid of the center console in a 2000 Toyota Avalon XLS, start by locating and removing any screws or fasteners that secure the lid. Often, these can be found under the lid itself or at the back of the console. Once the screws are removed, gently lift the lid upwards to detach it from the hinges. If it feels stuck, check for any additional clips or tabs that might be holding it in place.
To replace the console lid on a Chevrolet Tahoe, first, remove any screws or fasteners securing the old lid, typically located on the underside or back of the console. Gently pry off the old lid using a trim removal tool if necessary. Align the new lid with the hinge and press it into place, ensuring it securely attaches. Finally, reattach any screws or fasteners to complete the installation.
your trunk lid
in center console under lid
I had the same problem. Here's how I fixed it; you take off the cup holder assembly directly in front of the console lid by wedging a screwdriver on both sides and squeezing it with your other hand. This should unsnap it. Then the console lid and the cup holder should lift up together. Underneath you can see the latch where the console lid attaches to the cup holder assembly. I sprayed some WD-40 on the latch spring assembly and it pop free. Then you just snap back the cup holder which is now unlatched from the console lid. Thoroughly lubricate the latch spring assembly and it should work better.
To remove the center console lid of an Audi A4, start by carefully prying off any decorative trim pieces surrounding the lid using a trim removal tool. Next, locate and remove the screws or bolts securing the lid in place, which may be hidden under the trim. Once the fasteners are removed, gently lift the lid off the console, being cautious of any attached wiring for features like lights or switches. Always refer to your vehicle's service manual for specific instructions related to your model year.